Adjustable Chimney Pipe Wall Support Bracket — Fits 4″ to 8″ Pipe
One bracket, five pipe sizes · 0.4″–13″ adjustable wall clearance · Black powder-coated with stainless clamp ring
A wall-mount support bracket that keeps a vertical flue run straight, plumb and firmly anchored.The clamp ring opens from 4″ all the way to 8″, so the same bracket fits a 4″ single-wallstove pipe or a full 8″ chimney — you don’t have to guess the size before you order.
One Bracket, 4″ Through 8″Pipe SizeTypical UseFits This Bracket?4″Single-wall stove pipe, small stoves✓ Yes5″Single-wall and light double-wall runs✓ Yes6″The most common stove and fireplace size✓ Yes7″Larger fireplaces, workshop stoves✓ Yes8″Big fireplaces, long flue runs, cabins✓ Yes
The clamp is a continuous stainless band tightened with a bolt, so it grips anywhere in the4″–8″ range — not just at fixed steps. Measure your pipe’s outside diameter(double-wall pipe measures wider than its nominal size) and check it falls inside Pipe Diameter4″ – 8″ (outside diameter)Wall ClearanceAdjustable 0.4″ – 13″MaterialAlloy steel bracket + stainless steel clamp ringFinishBlack powder coating — heat and corrosion resistantOverall Dimensions15 x 9.4 x 2.4 inchesItem Weight3.3 poundsMountingWall mount — wood or concrete (expansion bolts included)Quantity1 bracket per orderWhy It Holds
Triangular side plates resist the sag. A triangle cannot deform the way a flat strap can, so the bracket keeps its shape under the weight of a long flue run — no drooping, no pulling away from the wall.- Clamp-on — no drilling into the pipe. The stainless band tightens around the outside of the flue with a bolt, so you are not puncturing the pipe wall or its insulation.
- One part number for every job. 4″ through 8″ on the same bracket means fewer SKUs to stock and no wrong-size returns.
- Set the gap you actually need. Wall clearance adjusts 0.4″ to 13″ — tight corners, thick masonry, eaves and offset runs all work.
- Built for heat and weather. Powder-coated alloy steel with a stainless ring; the coating handles flue heat and stops rust bleeding down your wall.
- Installs with hand tools. Mounting hardware and expansion bolts are included; wood and concrete walls both work.
Where It Goes
A wall support is needed wherever a vertical flue run is long enough to sway or lean — typically above the roof line, along exterior walls, and near the top of a tall stack.
Wood stoves and wood-burning fireplaces- Furnace flue pipe and workshop heaters
- Cabins, garages, saunas and off-grid builds
- Exterior runs on masonry, siding and timber frame
What’s in the box
1 x wall support bracket (triangular side plates + stainless clamp ring)- 1 x set of mounting hardware and expansion bolts
- 1 x installation instructions
Measure the pipe’s outside diameter — double-wall pipe is wider than its nominal size. It must fall between 4″ and 8″.- This is a support bracket only. Chimney pipe, elbows and caps are not included.
- Follow your local building code and the pipe manufacturer’s support-spacing requirements. If unsure, have the installation checked by a qualified installer.
Not sure it matches your setup? Send us your pipe’s outside diameter and a photo of the wall —we will confirm fitment before you buy. Ships from the US with tracking.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.