Case Lid Mount Compatible with Starlink Mini – Compatible with Apache, Black

• PACK WITHOUT THE PILE — When your satellite internet terminal is loose in the main compartment, it takes up the space you need for the rest of your travel gear. This case lid mount holds your terminal inside the lid instead, leaving the bottom available for other items as you pack for a campsite, a road trip or a workday away from home with your mobile internet gear.
• FULL CORNER CONTACT — Your epoxy bonds along curved contact surfaces that follow the inside corners of your case lid. The mount matches the corner radius of cases current in September 2026, creating full contact at the bonding surfaces so the adhesive meets the mount and lid along the intended curve when you prepare your terminal\'s storage space for travel.
• PLACE WITHOUT MEASURING — Skip the measuring, centering and spacing when you position the locating piece inside your case lid. It rests against the corners and outer wall to establish its position, turning the edges already in your case into your placement guide as you lay out the mount and trace its outline before preparing the bonding areas for installation.
• LOCK YOUR TERMINAL IN — Locking arms and thumb screws retain your satellite internet terminal in the mount, giving you controls to work with when packing it into your case. For assembly, bond the thumb-screw pieces to metal screws with epoxy or thick CA glue, keep the threads clear and attach the caps, then place a flat washer on each side of the locking arms at their contact surfaces.
• MAKE THE LID WORK — Bond the mount inside your case with two-part epoxy and let it set according to the adhesive\'s directions before loading your terminal. You get the plastic part only; three M4x6x6 threaded inserts, three M4x16mm socket head screws, six M4 flat washers, two-part epoxy, sandpaper and any other supplies your setup calls for are not included.

A loose satellite internet terminal takes over the bottom of your carrying case. When you pack for a trip, you end up arranging the rest of your gear around it instead of giving it a place of its own.

This case lid mount holds your satellite internet terminal inside the lid, leaving the main compartment available for other items. Its lid-contact surfaces follow the corner radius of the specified case geometry current in September 2026, giving the epoxy full contact along those curves. The locating piece rests against the corners and outer wall, so you position it without measuring, centering or spacing. Locking arms and thumb screws retain your terminal in the mount.

Start by laying out the mount inside your case lid and tracing the bonding areas with a pencil. Roughen the case plastic inside those marks with sandpaper; the source assembly uses 80 grit. Clean the areas with IPA, which also removes the pencil marks, before attaching the mount with two-part epoxy. Let the adhesive set according to its directions. The pieces fit tightly, so watch for adhesive squeezing out and keep excess epoxy out of the two corner mounts where it would block your terminal\'s insertion path.

To assemble the thumb-screw controls, bond the thumb-screw pieces onto the metal screws with epoxy or thick CA glue, keeping adhesive off the threads, then attach the caps. Place a flat washer on each side of the locking arms to create washer surfaces at the moving interfaces.

For travelers, campers and mobile internet users, this puts your terminal in the lid rather than among the items packed below. Use it in the carrying case you take between home, the car and your campsite, with a clear place to return your terminal when it is time to pack up. Your case bottom stays available for the other items you choose to carry.

Hardware details: the box holds the plastic part only. If your setup needs screws, adhesive or other fasteners, they are not included.