Banner PBA 16384 Multi-Beam Power Block 120VAC Photoelectric Sensor Open Box
$34.95

Banner Engineering PBA power block for the Multi-Beam photoelectric sensor family, Banner part number 16384 (box label \"PBA / 16384 / EID 3016384\", CE). Unit label: \"PBA, LR41887, INPUT: 120VAC, OUTPUT: 120VAC 100VA\", CSA mark. Side label: \"PBA, MFR CODE 0934A, CE\". Four screw terminals numbered 1 to 4 with captive washers.
A Multi-Beam sensor is built from three plug-together pieces: a scanner block, a power block and a logic module. The power block supplies the sensor and carries the output to your circuit. Banner distributor data for the PBA: 3 and 4 wire power block, input 105-130 V AC 50/60 Hz, output SPST solid-state switch, normally open, 3/4 A maximum, 250 V AC maximum; the output can switch a voltage different from the supply as long as both AC circuits share a common neutral.
What you get: one (1) Banner PBA power block in its original Banner box, as pictured.
Condition: New old stock, never wired. Housing has fine surface scratches on both sides and light storage dust (photographed), with no cracks. Not electrically tested. No manufacturer warranty is implied.
Install and wire by qualified personnel. Confirm supply voltage, output rating and your scanner block and logic module models against your application before energizing. Not tested beyond visual inspection.
What you see is what you get: photos are of the actual item. Ships boxed and protected, with tracking. Reasonable offers are always welcome. Questions before you buy? Message us, we answer fast.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.