AutoMeter Fits Universal GPS Speedometer Interface Module - 5289

Autometer Universal GPS Speedometer Interface Module - 5289

Brand: AutoMeter

ManufacturerPart: 5289

Product Category: Gauges & Pods~Gauges

Length: 5.1 inches

Width: 5.1 inches

Height: 4.8 inches

Weight: 0.7 lbs

The AutoMeter Universal GPS Speedometer Interface Module, part number 5289, provides a reliable way to complete electronic speedometer installations without a conventional vehicle speed sensor or mechanical cable. It is especially useful for off-road vehicles with large wheel and tire combinations, racing gearboxes, and custom applications where installation space makes traditional speed-sensing methods impractical. By using GPS-based speed data, this interface helps deliver accurate speedometer operation with minimal setup.

• GPS Module: Fully sealed against water and dust for dependable operation in demanding automotive environments. The included 6.5-foot wiring harness provides flexible installation options.


• Magnetic Micro Antenna: Fully sealed and paintable, with 16 feet of wiring to support versatile antenna placement and clean routing.


• Quick Calibration: One-touch calibration takes only seconds with most electronic speedometers, helping simplify installation and setup.


• Plug-and-Play Compatibility: Designed for use with AutoMeter electronic programmable speedometers for straightforward integration.


• Fast Signal Update: A 10 Hz signal update rate provides responsive speed data for performance and specialty vehicle applications.

The AutoMeter 5289 interface is built for installers who need a practical alternative to conventional speed sensors. Its sealed GPS module and antenna help protect the system from exposure to dust and moisture, while the generous wiring lengths make it easier to position components according to the vehicle’s layout. The system is well suited to modified vehicles, race cars, off-road builds, and other applications requiring a flexible electronic speedometer solution.
Installation should be completed according to the vehicle and speedometer manufacturer’s instructions. Verify compatibility with the intended electronic speedometer before installation. This product is intended for automotive applications and is not a direct replacement for every factory speed-sensing module is fully sealed against water and dust and includes a 6.5-foot wiring harness

Fully sealed and paintable magnetic micro antenna with 16 feet of wiring

One-touch calibration process takes only seconds with most electronic speedometers

Plug-and-play design for AutoMeter electronic programmable speedometers

Fast 10 Hz signal update rate for responsive speed data

Suitable for off-road vehicles, racing gearboxes, and custom installations