Excellent Audio Research LS3 PreAmplifier. All original, well taken care of (covered while not in use), and very clean in and out!!
Frequency response: ±.5 dB, 2.0 Hz to 100 kHz. -3dB points below 1 Hz and above 200 kHz
Distortion: (THD)Less than .01% at 2V RMS output. (Typically less than .005% in midband)
Noise & hum: 18 µV RMS maximum IHF weighted noise at main output with gain control minimum (more than 100 dB below 2V RMS output, or 4V balanced output (LS3B))
Gain: Main output: 18 dB (optional 10 dB gain reduction) Tape output: 0 dB Balanced output (LS3B): 24 dB
Input impedance: 50 kOhms (100 kOhms Direct)
Output impedance: 250 Ohms main output. 500 Ohms balanced (LS3B). Recommended load 60K Ohms and 100 pF (20K ohms minimum and 1000 pF maximum)
Output polarity: -
Maximum inputs: 20V maximum
Rated outputs: 2V RMS 2 Hz to 100 kHz, all outputs, 60K ohm load (maximum output 35V RMS (70V RMS balanced) (LS3B) at 1/2% THD at 1 kHz into 100K ohms)
Power supplies: Electronically-regulated low and high voltage supplies. Line regulation better than .01%.
Power requirements: 100-135VAC 60 Hz (200-270VAC 50/60 Hz) 25 Watts maximum (35 Watts maximum LS3B)
Dimensions: 19\" (48 cm) W x 5 ¼\" (13.4 cm) H (standard rack panel) x 10 ¼\" (26 cm) D. Handles extend 1 ⅝\" (4.1 cm) forward of front panel. Rear chassis fittings extend ½\" (1.3 cm)
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.