Anderic Substitute for Home Decorators Collection Merwry Ceiling Fan Remote Control | 303.9 MHz - 13431102701301, DL-4112T-01, 2A767-DL-4112T-01 [FAN35T]The Anderic FAN35T is a substitute for the Home Decorators Collection Merwry ceiling fan remote (DL-4112T-01). It is a radio frequency (RF) remote that runs at 303.9 MHz. How to confirm the fit Find the FCC ID on the back of your old remote or inside its battery compartment. It should match 2A767-DL-4112T-01. If your remote shows a different FCC ID, this remote will not work with your fan\'s receiver. Specifications Shipped remote: Anderic FAN35T Listed FCC ID 2A767-DL-4112T-01 identifies a replaced or compatible original remote, not automatically the shipped-stock certification Radio frequency (RF): 303.875 MHz Battery: 1 23A (not included) Good to Know Works with the receiver in your Merwry fan; it is not a universal remote Button layout may differ from your original remote Setup / Pairing Complete all receiver DIP, wiring, and canopy work with the circuit breaker off; reassemble, then restore power to test. If you later need to access the receiver again, isolate power at the breaker first. Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns. Battery Install a 23A 12-volt battery (not included). Remove the battery if the remote will not be used for a long time. Store the remote away from excessive heat or humidity. The remote has 16 code combinations. If your fan and light turn on and off without your remote, change the code combination on the remote. Pairing with a learning receiver (FAN30R) Remove the battery cover. Slide the code switches to your choice of up or down positions (factory setting is all up). Turn the fan\'s power off. Return power to the fan. Within 30 seconds of returning power, hold the LEARN key on the remote for at least 3 seconds. The light on the front of the remote blinks twice to confirm the receiver learned the code. Replace the battery cover. If your receiver has 4 dip switches Do not use LEARN. Set the remote\'s dip switches to match the receiver instead: Pairing by matching the dip switches (4-switch, 16 codes) Make sure the fan has power and works correctly. Push firmly below the arrow and slide the battery cover off the remote. Set the remote\'s 4 dip switches to EXACTLY the same up/down pattern as the switches on the fan\'s receiver. Use a small screwdriver or the tip of a ballpoint pen. The factory default is all switches up. Replace the battery cover and test the remote. Pairing without reaching the receiver Set the remote\'s dip switches to the first code pattern in the code chart (included with the remote). Press any button to test whether the fan responds. If it does not, move to the next dip switch pattern and test again. Repeat until the fan responds; there are 16 patterns. What\'s in the Box 1 Anderic FAN35T remote Battery not included Compatible Models Works with many Home Decorators Collection ceiling fans, including models such as SW1422WH, 13431102701301 and DL-4112T-01. Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list. Anderic Substitute for Home Decorators Collection Merwry Ceiling Fan Remote Control | 303.9 MHz - 13431102701301, DL-4112T-01, 2A767-DL-4112T-01 [FAN35T]
The Anderic FAN35T is a substitute for the Home Decorators Collection Merwry ceiling fan remote (DL-4112T-01). It is a radio frequency (RF) remote that runs at 303.9 MHz.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match 2A767-DL-4112T-01. If your remote shows a different FCC ID, this remote will not work with your fan\'s remote: Anderic FAN35T
Listed FCC ID 2A767-DL-4112T-01 identifies a replaced or compatible original remote, not automatically the shipped-stock certificationRadio frequency (RF): 303.875 MHzBattery: 1 23A (not included)Good to Know
- Works with the receiver in your Merwry fan; it is not a universal remote
- Button layout may differ from your original remote
Setup / Pairing
Complete all receiver DIP, wiring, and canopy work with the circuit breaker off; reassemble, then restore power to test. If you later need to access the receiver again, isolate power at the breaker first.
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code a 23A 12-volt battery (not included). Remove the battery if the remote will not be uséd for a long time.
Store the remote away from excessive heat or humidity.The remote has 16 code combinations. If your fan and light turn on and off without your remote, change the code combination on the remote.Pairing with a learning receiver (FAN30R)
- Remove the battery cover. Slide the code switches to your choice of up or down positions (factory setting is all up).
- Turn the fan\'s power off.
- Return power to the fan.
- Within 30 seconds of returning power, hold the LEARN key on the remote for at least 3 seconds. The light on the front of the remote blinks twice to confirm the receiver learned the code.
- Replace the battery cover.
If your receiver has 4 dip switches
Do not use LEARN. Set the remote\'s dip switches to match the receiver instead:
Pairing by matching the dip switches (4-switch, 16 codes)
- Make sure the fan has power and works correctly.
- Push firmly below the arrow and slide the battery cover off the remote.
- Set the remote\'s 4 dip switches to EXACTLY the same up/down pattern as the switches on the fan\'s receiver. Use a small screwdriver or the tip of a ballpoint pen. The factory default is all switches up.
- Replace the battery cover and test the remote.
Pairing without reaching the receiver
- Set the remote\'s dip switches to the first code pattern in the code chart (included with the remote).
- Press any button to test whether the fan responds.
- If it does not, move to the next dip switch pattern and test again. Repeat until the fan responds; there are 16 patterns.
What\'s in the Box
- 1 Anderic FAN35T remote
- Battery not included
Compatible Models
- Works with many Home Decorators Collection ceiling fans, including models such as SW1422WH, 13431102701301 and DL-4112T-01.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
× × × × × ×
Shipping info
Click the Shipping & Payments tab above the listing description for more info
Price: $7.95 (local shipping)
Click the Shipping & Payments tab above the listing description for more info!
Additional delivery notes
PICK UP OPTION
Sorry, our items are NOT available for pick-up.
PAYMENT
Immediate payment is required upon selecting \"Buy It Now\" or upon checking out through the cart.
We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay.
We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus).
The applicable amount of sales tax charged to an order will be calculated based on the shipment destination\'s state and local sales tax laws.
Thank you for shopping with us on !
Additional Information
No additional information at this time
Ask seller a question
You might also like Anderic Substitute for Overhead Door OUK 3-Door Wireless Keypad Wall Console wit Anderic Substitute for Genie GUK-R Keypad Compatible with LiftMaster Chamberlain Anderic GUK-R Keypad Compatible with LiftMaster Chamberlain Genie Craftsman and LG MR26GA Magic Remote Control with AI, Voice, and shortcuts | RF - AKB30086802 Contact
To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist.
Ask seller a question
© Anderic
Shipping & Payments
Shipping is a flat rate across US at a rate of $7.95
Payment
Accepted Payment Methods
Immediate payment is required upon selecting \"Buy It Now\" or upon checking out through the cart.
We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay.
We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus).
The applicable amount of sales tax charged to an order will be calculated based on the shipment destination\'s state and local sales tax laws.
Thank you for shopping with us on !
Returns
Returns are accepted
Items must be returned within 30 days of the sale ending
Buyer will pay for return shipping.
integration by
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.