Aftermarket KUTAI GCU-10 GCU10 Automatic Controller for Generator Control Unit

Part Number:
GCU-10, GCU10

Description:
The GCU-10 is an economical genset controller, giving high reliability for much less than similar controllers. It has adjustable settings to enable it to work with any type of generating set and comply with different engine conditions and protections. Optional 12V/24V relay boards (GCU-11R) are available for simplifying wiring and connections.

Feature:
Microprocessor Based Design
Universal LED Graphic Interface, Displays Generator Status and Failures
Modular Design, Quick Installation
Programmable Engine & Generator Controls Adapts Easily To Any Type Generator Set.
Waterproof Front Panel With UV Protection
Provide IDLE control For Elec. Governors
Five Adjustable Time Delay Potentiometers
Five DIP Switches For Specification Setting

Specification:
DC Supply:9.0 to 36 VDC
Alternator Input Range:Voltage 5~300 VDC Frequency 50~60 Hz
Fuel Solenoid Signal Output:5 Amp @ 12/24 VDC
Start Signal Output:5 Amp @ 12/24 VDC
Warm up Signal Output:5 Amp @ 12/24 VDC
Accessory \" ON \" Output:5 Amp @ 12/24 VDC
Idle Control Conductor Capacity:5 Amp @ 12/24 VDC
Power Consumption:Under 3 VA on Auto
Adjustable Timers:
Engine Pre-Heat : 2~30 sec.
Starter Cranking Time : 1~15 sec.
Energize to STOP : 1~15 sec.
Engine Idle (Governor) : 0~300 sec.
Engine Cool-down : 0~300 sec.
Environment:
Operation Temperature : -20~70 °C
Relative Humidity : Maximum 90%
Protection & Alarm Status Indicators:
Start Failure
High Water Temperature
Low Oil Pressure
Overspeed
Underspeed
Emergency Stop
Extra Prog. Input
Low Battery Voltage
Panel Installation Cut-Out:66.0 x 66.0 ±0.5 mm
Dimensions:72.0 (L) x 72.0 (W) x 50.0 (H) mm

On May 20, 2025 at 21:15:12 PDT, seller added the following information: