Adafruit LPS35HW Pressure Sensor, Waterproof, for Arduino/Raspberry Pi,4258

Adafruit LPS35HW Pressure Sensor, Water Resistant, for Arduino/Raspberry Pi,The description of this item has been automatically translated. If you have any questions, please feel free to contact us.



Paradisetronic.comYour Store for DIY Electronics

Adafruit LPS35HW air pressure sensor, water resistant

The Adafruit LPS35HW Breakout Board is particularly suitable for air pressure measurement in humid environments and when relative pressure changes and / or the absolute air pressure are to be measured. The sensor element is water-resistant and can therefore also be used in wet rooms.

The control takes place via I2C bus or SPI interface and can be easily implemented with Allen microcontrollers. Inside the sensor there is an already calibrated 24-bit A / D converter for pressure measurement. Temperature measurements are possible with a resolution of 16-bit. The sensor covers a measuring range from 260 to 1260 hPa and provides a measuring accuracy of ± 0.1%. The data rate can be set and measurement noise can be minimized using an integrated low-pass filter. The measured values ​​are corrected for temperature influences.

There is already a level converter on the breakout board so that the board can be operated at both 3.3 V and 5 V. You can solder on the enclosed pin header if necessary.

Please note that only the sensor element is protected from water, but not the circuit board itself. If you plan to use it in a humid environment, it is advisable to seal the rest of the board in waterproof epoxy.

For more information and sample code, please visit the Adafruit website: Adafruit LPS35HW Breakout Board is particularly suitable for air pressure measurement in humid environments and when relative pressure changes and / or the absolute air pressure are to be measured. The sensor element is water-resistant and can therefore also be used in wet rooms. The control takes place via I2C bus or SPI interface and can be easily implemented with Allen microcontrollers. Inside the sensor there is an already calibrated 24-bit A / D converter for pressure measurement. Temperature measurements are possible with a resolution of 16-bit. The sensor covers a measuring range from 260 to 1260 hPa and provides a measuring accuracy of ± 0.1%. The data rate can be set and measurement noise can be minimized using an integrated low-pass filter. The measured values ​​are corrected Marke Adafruit EAN Nicht zutreffend Modell Adafruit LPS35HW Water Resistant Pressure Sensor Herstellernummer 4258 Herstellungsland und -region Vereinigte Staaten Produktart Sensor