Adafruit Feather M0 Express, Designed for CircuitPython, 3403
At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0+ processor, clocked at 48 MHz and at 3.3V logic, the same one used in theArduino Zero. This chip has a 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much). This chip comes with built in USB so it has USB-to-Serial program and debug capability built in.
Measures 2.0\" x 0.9\" x 0.28\" (51mm x 23mm x 8mm) without headers soldered in5 grams256KB of FLASH + 32KB of RAMNo EEPROM32.768 KHz crystal for clock generation & RTC3.3V regulator with 500mA peak current outputUSB native support, comes with USB bootloader and serial port debuggingYou also get many pins - 20 GPIO pinsHardware Serial, hardware I2C, hardware SPI supportPWM outputs on all pins6 x 12-bit analog inputs1 x 10-bit analog ouput (DAC)Built in 100mA lipo charger with charging status indicator LEDPin #13 red LED for general purpose blinking4 mounting holesReset buttonEasy reprogramming: the Feather M0 comes pre-loaded with theUF2 bootloader, which looks like a USB storage key. Simply drag firmware on to program no special tools or drivers needed. It can be used to load up CircuitPython, PXT MakeCode or Arduino IDE (it is bossa-compatible)
Comes fully assembled and tested, with the UF2 USB bootloader. Headers are included so you can solder it in and plug into a solderless breadboard.
Lipoly battery and USB cable not included.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.