ATMEGA328P Development & Educational Kit with full guide (Breadboard/Protoboard)

This ATMEGA328 Breadboard kit allows you to build out your very own MCU on abreadboard/protoboard. The ATMEGA328 is the chip used on the famous Arduino Uno, and it features32KB of Flash and 2KB SRAM. The chip runs on 1.8-5.5v and can reach a top frequency of 20MHz (at4.5v+). Native programming is available via SPI, however the preinstalled bootloader allows uploadingsketches over UART. This kit is ideal for low power applications, early prototyping, space-bound system,and most importantly: education.

Quick note: This ATMEGA is pre-burned with a bootloader and is set to run off of the 8mhz internaloscillator, if you wish to use a higher frequency external oscillator, uploading the bootloader is verysimple.

Happy building!

Datasheet can be found at:MeridianElectronic.com

PARTS IN KIT:

- ATMEGA328P

- 3.3v 0.8A LDO

- NE555

- 25AA320A (EEPROM)

- 8 100nF ceramic capacitors

- 2 1uF ceramic capacitors

- 47uF electrolytic capacitor

- 100uF electrolytic capacitor

- 0.5A polyfuse

- 1A Schottky Diode

- Ferrite Bead

- 5 33 Ohm Resistors

- 3 470 Ohm Resistors

- 3 1k Ohm Resistors

- 5 4.7k Ohm Resistors

- 5 10k Ohm Resistors

- 3 Green LEDs

- 2 Tactile Switches

- 1 USB-UART Programmer

CHIP SPECIFICATIONS:

Core: 8 Bit AVR RISC, 28-pin DIP Package, up to 20MHz with external oscillator

Memory: 32KB Flash, 2KB SRAM, 1KB EEPROM

Power: 1.8-5.5v, 0.2mA active draw @ 1 MHz 1.8v, 0.1uA at 1.8v power-down mode

IO Peripherals: 23 GPIOs, 6 PWMs, 6 ADCs, 1 UART, 1 SPI, 1 I2C/TWI

Other: 8MHz internal RC Oscillator, 2x8 bit and 1x16 bit timers, 2 external interrupts

4MHz @ 1.8v

10MHz @ 2.7v

20MHz @ 4.5v+

APPLICATIONS:

● Embedded systems prototyping & education

● IoT sensor nodes

● Robotics & motor control

● Lower-power applications

● Custom Arduino-alternative projects

● Space sensitive system