Price is for one sight
Here is an unused CVA Rear adjustable sight. It will fit a 1\" & 15/16\" barrel. It will not fit the 3/4\" and 7/4\" barrel.
It is fully adjustable for windage and elevation. These were used on both rifles and pistols. It is held on with a wedge that is included. Of course it will fit some traditions and others that have the rear sight held on with a wedge. The wedge is approximately:
Height ranges from .087 to .101
Width ranges from .369 to .377
Length ranges from .364 to .381
Measuring with a straight edge it is:
2 5/16\" over all long.
The base is 9/16\" wide.
The height of the top of the \"V\" notch, which you would use to align the front sight with goes from a low of .439 to a height of .580.
In order to install this sight you have to remove the pivot pin, install it to your barrel, install the spring and then reinstall the pivot pin. The pivot pin easily comes out. You just need a small punch.
If needed I also have some parts listed for this sight.
This is a stock picture and only comes with what is pictured
NOTE: This part goes on a muzzleloader, blackpowder gun.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.