8 Gang Push Button Switch Panel RGB Backlit Waterproof 8 Fused Circuits 60A RV

Toggle Press once to switch on, press again to switch off. The everyday setting for lights. Momentary Only runs while you hold the button — ideal for a winch or an air horn. Flash Pulses the output while the circuit is on. Good for a rear work light or warning lamp. Strobe Fast emergency pattern for beacons and hazard lighting.

Voltage 12V / 24V DC Maximum power 720W at 12V / 1440W at 24V Maximum current 60A total Circuits 8 (independently fused) Fuse rating per circuit CH1-4: 30A / 20A / 15A / 10A · CH5-8: 30A / 20A / 15A / 10A Operating temperature -40°C to +85°C Waterproof rating IP65 (panel and control box) Relay type Built-in solid state relay Protection 60A resettable circuit breaker + 8-way fuse block Terminals Nickel-plated copper Backlight 8 colours + gradient + breathing, auto-dimming Memory Remembers the last switch state after power off Panel finish Black textured ABS, pre-printed function icons

1. Switch panel
2. Circuit control box
3. Mounting brackets
4. Double-sided adhesive pad
5. Installation kit
6. 60A circuit breaker
7. Inline fuse wire 8. Negative lead
9. Positive lead
10. Wire harness
11. Cable ties
12. Label sheet
13. User manual

1. Mount the panel

Stick it down with the supplied pad, or bolt it up with the bracket set.

2. Mount the control box

Under the bonnet or behind a trim panel, using the same bracket system.

3. Run the circuits

Power it from the battery (recommended) or an ACC feed, then wire each accessory.

Before you wire it up: disconnect the negative battery terminal first. Power the control box from the battery rather than an ACC feed where possible — an ACC feed can drop out during cranking and reset the panel. Match the fuse to the load, not to the biggest fuse that fits, and never exceed 60A total across all eight circuits. If you are unsure about a circuit, have it fitted by an auto electrician.