6V 12V 24V PWM DC Motor Speed Controller Reversible Switch Adjustable Governor

Product description:

• Color:As Pictures Show

• Model: CCM6N

• Input supply voltage: DC 6V-30V

• maximum output power: 200W

• Net weight: 70g

• Dimension: 74*47*28mm

• Rated Amperage: 6A

• Maximum Amperage: 10A

• Duty Cycle adjustable: 0-100%

• PWM frequency: 16kHz

• Power-On LED indicator

• Features:

• The DC Motor Speed Controller allows controlling both the speed and direction of a DC motor using a Pulse-Width-Modulated (PWM) DC voltage with a Duty Cycle fully adjustable from 0%-100% (both Positive and Negative DC output)

• The motor speed controller incorporates a high power MOSFET with a heat sink and can easily provide a continuous current of 6A to your DC motor or other DC load.

• The circuit also includes LED whose brightness varies proportional to the relative speed of the motor therefore giving a visual response of the current speed.

• The positive inversion switch is used to control the direction and stop of the motor.

• Can adjust the speed by the external 0-5V signal

• NOTE:This can NOT be used to the BRUSHLESS motor.

• The controller is NOT reverse-polarity protected and will be damaged if connect the supply voltage with wrong polarity.

• Double check all connections before applying power and always turn off the power supply before making any wiring changes.

• The use of 0-5V external voltage control line description

• NOTE:

• This can not be used to the brushless motor

• WARNING: DO NOT REVERSE POSTIVE AND NEGATIVE POWER LOADS.THIS WILL DAMAGE THE CONTROLLER.

• Main Usage:

• widely use to people DIY, hobby, scientic test, such as control computer Ipad fan speed, control bulb, control motor kymco,control xbox360, HHO Pluse Width modulator, Test Equipment, industrial automation, speed regulator module board support PLC,motor electric pump fan speed control, PWM HHO RC controller,remote control toys, etc......

• The speed controller supports the use of an external DC voltage control. Using the following steps:

• First, remove potentiometer. (you may take it down from one side of the circuit board or potentiometer side down under your need);

• Second, connecting 0-5V DC control signal to the middle pin connector (mark 0-5V);

• Third, connecting the earth wire of 0-5V DC control signal to the connecting piece on the pin marking GND

Package included:

• 1 x 6 - 30V 6A DC Motor Speed Controller