Focusable 405nm 500mW Dot Laser Module With Driver
Package: 1pc 405nm 500mW Laser, 1pc 3pin cable, 1pc 3pin-4pin cable
Laser Features:
Laser Interface: 3PIN (PWM GND 12V+),
Laser shape: Dot
Focusable: Yes
Modulation frequency: TTL/PWM, TTL controls switch, PWM controls output.
Fan Cooling
Working Voltage: 12V
Case Material: Aluminum
Warm-up time: None
Operating Temperature: -40 ℃ ~ +50 ℃
Storage temperature: -40 ℃ ~ +50 ℃
The laser interface has three pins, with the red wire connected to a 12V+power supply, the yellow wire connected to a PWM+signal, the black wire connected to a power supply GND, and the white wire connected to a signal GND. The power supply and signal are grounded together! If the signal is not connected, simply connect 12V+and GND to emit light! No need to connect the signal again, the signal is only used to control the switch or adjust the power!
1. Recommended engraving distance: 2-10cm
2. Combustible materials: wood, paper, plastic, leather, bamboo, rubber, gourds and other materials that can be burned by fire. Can be cut: thin paper can be cut, other materials basically cannot be cut!
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.