4Pack Wireless N64 Controller for Nintendo 64 Console PC Windows Switch Switch 2

Compatibility Notes:This controller is supplied with two distinct receivers:N64 receiver: compatible exclusively with N64 consolesStandard USB receiver: compatible with Switch, Switch 2, Windows PCs, and macOS devicesPairing Tip for Switch / Switch 2:For proper functionality with Switch / Switch 2, please complete the following setting before pairing:Go to System Settings - Controllers and Sensors - Pro Controller Wired Communication, then turn this setting ON.Recommended Emulators:For Windows PC: Project 64For macOS device: OpenEmuPackage Contents:4 x Wireless N64 Controllers4 x N64 Receivers4 x USB Receivers4 x USB-C Charging Cables2.4 Ghz Wireless Game Controller for Nintendo 64 Console N64 Game System； For RetroPie, PC Windows, Switch, HyperSpin, MAME, NeoGeo FBA Emulator, Raspberry Pi GamepadWireless Controller Perfectly Compatible With N64 /Switch & Switch Lite

• This controller is supplied with two distinct receivers:
• Widely Compatibility
• Use a N64 Original port(included), mainly works with Nintendo 64 Entertainment System Console.
• Use a USB 2.4 GHz receiver(included), it can run Windows PC, Mac and Raspberry PI .
• Compatible with Switch, Switch 2, Windows PCs, and macOS devices

How to pair on the switch:

1.Click the menu “System settings “by Switch Joypad , find the icon”Controllers and Sensors” and click the button“ Pro Controller Wired Communication\" must be ON status.

2.Plug the receiver into your switch and the red led starts flashing, press and hold the \"SYNC\" button on the receiver until it fast-blinking.

3. Press the\"Reset“ button on the top of the controller , the led on the controller starts flashing.

4. Press the\" Start” button, the LED stays lit and the controller is connected.

Q: When the controller didn’t work and connect the switch?

A: For Switch, please sets the icon\" Pro Controller Wired Communication is ON \" in the system settings.

Q: Why the rumble feature is not supported the MAC or switch?

The rumble feature are activate when it is working for the N64 consoles or by selecting X-input mode and configuring additional settings such as “rumble” in the emulator.

Notice： When you switching devices, you have to re-pair the controller, please press the “reset”button, then pair the controller step by step as if it were used at the first time

How to pair your N64 device:

1)When you first pair the controller, Plug in the N64 receiver to N64 console, then press the \" reset“ button of the gamepad.

2)Press the START button to wake up the controller, and the light flashes quickly.

3)Finally, please press the button on the receiver for 3S, the red LED will flash rapidly and is always on after the pairing successfully.

Note: When connecting to your Switch Console:1,\"Pro Controller Wired Communication\" must be enabled before pairing: Mean that:\"Pro Controller Wired Communication\" shown:OnTo play N64 games on Switch, enter All-Star mode by pressing and holding the Start + A buttons for 5 seconds.

Quick Troubleshooting:

1. Not charging: Hold the top Reset button for 3 seconds to reset

2. USB receiver light off / unable to pair: unplug and re-plug the USB receiver

3. Stuck in upgrade mode: Hold the top Reset button for 3 seconds to reset

4. Project64 not detecting controller: Pair first, then open the emulator (no hot-plug support)

5. No rumble on PC (Project64): Switch to X-input mode and enable rumble in emulator settings