|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
3Pcs MCP4725 I2C DAC 12-Bit Digital Analog Converter Module Red Board
$18.99

Product description Product Parameters Operating Voltage 2.7V–5.5V DC (Wide Voltage, Direct MCU Power Compatibility) Resolution 12-bit (4096 Steps Output Precision) Interface I²C Communication (Supports 100kHz/400kHz/3.4MHz Modes) Quiescent Current ≤0.4mA (Normal Mode); ≤60nA (Standby Mode) Output Type Buffered Voltage Output (0V to VDD, Rail-to-Rail) Storage Internal EEPROM (Power-Off Memory Retention) Operating Temperature -40°C to +125°C (Reliable) Module Size 20mm × 15mm (Red PCB, Breadboard Compatible) Pin Functions - VCC: Power Input (2.7V–5.5V DC). Connect directly to MCU power source
- GND: Power Ground. Share common ground with system.
- SCL: I²C Clock Line. Requires external 4.7kΩ pull-up resistor to VCC; SDA: I²C Data Line. Requires external 4.7kΩ pull-up resistor to VCC.
- A0: Address Configuration Pin (Ground/VCC Switchable for I²C Address 0x60–0x63).
- OUT: Analog Voltage Output (Max Load Current 25mA).
-
I²C Communication Fails? Ensure 4.7kΩ pull-up resistors on SCL/SDA to VCC; verify address (default 0x60) or adjust via A0 pin. -
Output Voltage Unstable? Stabilize power supply (ripple 5ms between writes; avoid frequent writes (EEPROM endurance ≈1 million cycles). - 【12-Bit Precision DAC Module】12-bit resolution; 4096-level output; rail-to-rail voltage output from 0V to VDD; Suitable for audio signal generation and sensor calibration.
- 【I2C Interface Compatibility】I2C digital communication; supports 100kHz, 400kHz, and 3.4MHz modes; compatible with for Arduino, for Raspberry Pi, and STM32 microcontrollers.
- 【Low Power Consumption】0.4mA normal mode; 60nA standby mode; built-in EEPROM stores last settings; suitable for battery-powered portable devices.
- 【Industrial Temperature Range】Operates from -40°C to +125°C; wide voltage input 2.7V to 5.5V; no external amplifier required for loads up to 25mA.
- 【Easy Setup and Reliable Performance】Address configurable via A0 pin; multi-module parallel connection supported; includes pull-up resistors for SCL and SDA lines; not for high-voltage (>50V) systems.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|