3 Pack GY-BME280 3.3V Temp Humidity Pressure Sensor Modules I2C SPI Pre-Soldered Description:
Specifications
Interface:I2C and SPI
Supply Voltage:3.3V
Measurements:Temperature, Pressure, Humidity. Pressure can be converted to altitude.
Compatibility:for Raspberry Pi and for Arduino Models, and any microcontroller with I2C or SPI capabilities.
Note: Soldering Comes Pre-Soldered.
Pins:
VCC: This pin is used for Supply Voltage.
GND: This pin is used for ground.
SCL: This pin is used for the clock pulse for I2C communication.
SDA: This pin is used for transferring data through I2C communication.
CSB: This pin can be used to allow multiple devices to share the same I2C bus.
SDO: This pin can be used to select the device\'s I2C address when multiple BME280 sensors are connected to the same I2C bus.
Package Included:
3* Pre-Soldered BME280 3.3V Temperature Humidity Sensor Module
Features:
- you will get 3pcs BME280 3.3V Pre-Soldered High Precision Altimeter Atmospheric Pressure, Temperature, and Humidity GY-BME280-3.3 Sensor Module
- BME280 is a precision sensor, is soldered onto PCB. It uses both I2C and SPI (supports 3-, 4-wire SPI) interface.
- Pressure: 300-1100 hPa; Temperature: -40 to +85°C ; Humidity: 0-100%
- BME280, the precision sensor from , is soldered onto PCB. Not only the pressure and the temperature, this sensor can measure humidity. It uses both I2C and SPI (supports 3-, 4-wire SPI) interface
- Interface: I2C (up to 3.4MHz), SPI (up to 10 MHz); Measures Pressure, Humidity, and Temperature with I2C and SPI Interfacing
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.