2pcs SHT31-D SHT31 Temperature Humidity Sensor Module GY-SHT31-D Breakout
$15.99

SHT31-D Temperature Humidity Sensors Specifications:
Power supply voltage: 2.4-5.5V (typically 3.3V)
RH response time: 8 seconds (tau63%)
Operating temperature range: -40° to 125°C (-40° to 257°F)
Precision tolerance: +/- 2%; RH +/- 0.3\"
Interface: I2C
Power Pins:
Vin - this is the power pin. The chip can use 2.5-5V DC for power. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V micro, use 5V. For a 3.3V controller, connect to 3.3V GND - common ground for power and logic
SCL - I2C clock pin, connect to your microcontrollers I2C clock line. This pin has a 10K pullup resistor to Vin
SDA - I2C data pin, connect to your microcontrollers I2C data line. This pin has a 10K pullup resistor to Vin
ADR - This is the I2C address selection pin. This pin has a 10K pull down resistor to make the default I2C address 0x44. You can tie this pin to Vin to make the address 0x45
RST - Hardware reset pint. Has a 10K pullup on it to make the chip by default. Connect to ground to do a hardware reset!
ALR - Alert/Interrupt output. You can set up the sensor to alert you when an event has occured. Check the datasheet for how you can set up the alerts
Package Included:
2* SHT31-D Temperature Humidity Sensor
SHT31-D humidity sensor power supply voltage is 2.4 to 5.5V.
SHT31-D temperature and humidity sensor has excellent ±2% relative humidity and ±0.3°C accuracy for most applications.
The gy-sht31-d temperature humidity sensor output is iic i2c interface, communication rate up to 1MHz, with two user-selectable addresses.
SHT31 Operating temperature range: -40° to 125°C (-40° to 257°F).
RH response time: 8 seconds (tau63%).

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.