Operating Instructions for 02023 Magnetizer 1. Purpose
This magnetizer can magnetize various magnets and demagnetize pre‑magnetized materials. It can also be used for demonstration experiments including the magnetic effect of electric current, electromagnet principles, electromagnetic induction, and force‑driven motion of energized coils inside a magnetic field.Since the magnetic field supplied by common laboratory equipment is usually weak and yields indistinct results, this instrument generates a strong magnetic field to greatly improve experimental performance.
It is an essential device for physics experiments in middle‑school classrooms, and is also widely used in universities, research laboratories, watch‑making factories, magnet‑manufacturing plants and other sectors.
2. Structure & Working Principle
This device is designed based on the principle that a magnetic field is generated around an energized coil.During magnetization, internal components convert alternating‑current power into direct‑current power. During demagnetization, alternating‑current power is applied directly.
3. Operation Methods 1) Magnetization
Connect the instrument to a 220 V AC power supply.(1) Insert one end of the bar magnet or bar‑shaped magnetic material deep into the socket hole. Press and hold the button for about 1‑2 seconds, then release it. Repeat this operation 3 times, then take out the material to complete magnetization.(2) Insert one end of the horseshoe‑shaped magnetic material deep into the socket hole. Press the button for about 1‑2 seconds and then release. Repeat 3 times, pull the workpiece out, insert its opposite end into the other socket hole and repeat the same process. Magnetization is finished afterwards.(3) N‑pole and S‑pole marks are printed on both sides of the sockets. The pole marked beside the insertion hole will become the polarity of that end of your workpiece after magnetization.
2) Demagnetization
Connect to the 220 V AC power supply. Wipe the workpiece to be demagnetized and insert it into the socket hole. Press the button switch, then slowly pull the workpiece out of the socket (move about 30 cm away from the unit). Release the button, insert the opposite end of the workpiece into the second socket hole and repeat the above demagnetization procedure. Demagnetization is then completed.
For small parts that can be fully placed inside one socket hole, one single pull‑out operation is enough for full demagnetization.
3) Demonstration Experiments
This instrument contains a coil with a large number of turns, producing far more obvious experimental results than ordinary lab equipment for demonstrations of current magnetic effect, electromagnet principles and electromagnetic‑induction phenomena.Better testing performance can be achieved by inserting silicon‑steel sheets or A3 soft‑iron as an iron core into the socket hole.
Precautions
- Do not keep the power switched‑on for an excessive time to prevent overheating.
- Keep this instrument at least 30 cm away from magnetic‑type meters during operation to avoid interference.
packing;1pc
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.