- 1-Inch body length includes 3 matching Sc1 Keyway keys
- For use with commercial storefront deadlock or hook locks
- Fits Adams Rite & many other storefront commercial or residential doors
- Brass cylinder and housing; very high quality, durable, secure, and strong
- Includes 5/16-inch stamped trim ring
Product Description Ri-Key Security - Set Of 2x Keyed Mortise Lock Cylinders 1\"
Standard 1-inch length, standard 1-5/32\" diameter commercial door lock mortise cylinders fit Adams Rite, Kawneer, Vistawall, & Most other Storefront Door Locksets
CYLINDER SIZE:
Standard 1-inch Length - the most common size cylinder for commercial glass/aluminum storefront doors. However, there are other common sizes such as 1-1/8\" or 1-1/4\". Please confirm your lock size to avoid mismatch!
CAM TYPE:
The lock cylinders have Adams Rite cam for use with Adams Rite, Kawneer, Vistawall, & most other storefront door locksets. If your lock uses a different cam type, this may not fit your setup.
DOOR/LOCK TYPES:
For use with commercial store front, glass doors with narrow aluminum frame with deadbolt, hook lock, or deadlatch.
Also fit many residential doors with mortise lock set, please confirm lock size and cam to ensure your lock accept this type of cylinder.
Each set includes
2 Keyed lock cylinders & 4 matching keys, and 2 trim ring
INSTALLATION Unscrew
Unscrew face-plate screws and loosen the Set screws (flat-head/hex small ones, located behind the face-plate)
Remove Old Cylinder
Unscrew the old mortise cylinder off your lock, by turning it counterclockwise.
If you have an Anti-Wrench Mortise Cylinder Guard around it, you can use an old key as a tool, insert it into the key hole and carefully use it to help you get the initial turn to loosen the cylinder (be careful not to break it inside the cylinder).
If you find it difficult to turn, you can try to loosen the 2 mounting screws that hold the lock on the door. Don\'t remove them! Just loosen them to allow the mortise lock and cylinder to be more free inside the door frame.
Install New Cylinder
Start by turning the cylinder counterclockwise until you feel your new cylinder and mortise lock threads are aligned.
Turn your new cylinder clockwise until it is deep enough to engage the mortise lock pivot pin.
*Use extreme caution not to cross thread the cylinder as this may ruin the entire lock!
* Do not over tighten the cylinder. If the cam touches the metal lock rod behind it, it will prevent it from turning smoothly.
* If you find it difficult to screw in, you can try to loosen the 2 mounting screws that hold the lock on the door. Don\'t remove them! Just loosen them to allow the mortise lock and cylinder to be more free inside the door frame.
Mountaing Screw / Face-plate
Align the cylinder so that the keyway is in the same position as it originally was (usually to the bottom, parallel to the door frame).
* Your new mortise cylinder has 2 grooves on both sides. The set screws must be aligned with one of those grooves to secure the cylinder in place!
Tighten the set screw until your new cylinder cannot move in place.
Screw back the face-plate.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.