12V Multifunctional Relay Module PLC Delay Timer Switch Self-Lock Home Automatio

Feature:

Function 1:Timing Pick: After power relay delay time T1, T1 in 0 seconds
adjustable between -270 hours, give CH1 connector is a high pulse signal
(high duration is greater than or equal 20ms, hereinafter the same), repeat the above functions

Function 2:Timed disconnect: On power relay, time relay off delay time T1,
T1 in 0 seconds adjustable between -270 hours, giving a high level
pulse signal CH1 connector, repeat the above functions

Function 3:Loop Timing Mode 1: After power on, to not pull the relay, the delay time
T1 after arrival relay; pull the relay off time T2 after arrival, and then repeat the above state,
the delay time T1 and T2 in 0 seconds adjustable between -270 hours, giving a high level pulse
signal CH1 connector, you can resume these functions

Function 4:Loop Timing Mode 2: After power, the relay immediately pull, delay time
T1 after arrival relay off; off time T2 arrives relay, and then repeat the above state,
the delay time T1 and T2 in 0 seconds - adjustable between 270 hours and give CH1
connector is a high pulse signal, these functions can be re-started

Function 5:Latching relay mode: CH1 connector to relay a high level pulse signal,
the relay, to give a high level pulse signal relay disconnected

Function 6:Trigger relay mode: CH1 connector to a high signal relay,
relay, high disappeared, relay disconnected

Function 7:Finite loop timing mode 1: Function 3, based on the number
of cycles increased functionality, then T1 and T2 in 0 seconds -9999 seconds
adjustable between 1-9999 times in between cycles adjustable

Function 8:Finite loop timing mode 2: In function 4, based on the number of cycles
increased functionality, then T1 and T2 in 0 seconds -9999 seconds adjustable
between 1-9999 times in between cycles adjustable

Function 9:Customized Mode: Reserved

Two module interface:
Module control side: there are 3-wire interface, all interfaces are terminal, user-friendly
DC+: DC power supply positive(with 5V, 12V and 24V modules to choose from)
DC-: DC power cathode
CH1: Hold Input Detection Interface
Relay outputs: A 3-wire interface, all interfaces are terminals
NO1: normally open relay interface, the relay becomes vacant before, pull shorting after the COM1
COM1: Relay Common Interface
NC1: normally closed relay interface relay shorted before and COM1, pull vacant post
Module:12V

Package included:
1 x Multifunctional relay module