|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Yamaha Banshee CDI & Voltage Regulator Relocation Bracket Mount Kit, Trail Tech
$50.00

Yamaha Banshee CDI/Regulator Under Seat Relocation Bracket KitBracket ONLY, NO CDI Included! Please read the description! (I will not accept any returns for lack of reading the description!)This mount relocates the CDI and Factory AC Voltage Regulator (or Trail Tech DC Rectifier/Regulator) from the rear of the ATV to under the front of the seat. This location allows easy access to the electronics and wiring as well as eliminates the need for the wiring harness extension to the rear of the quad. Also it does not interfere with removal of the seat or gas tank and keeps them better protected than putting them in the front. Typically used when eliminating the TORS and misc electrical items like explained in \"DFN\'s Banshee Electrical FAQ\" (Thanks for his hard work explaining Banshee Elecrical!) for a simplified clean wiring harness. The stator plugs directly into the CDI (no extension needed) and all of the plugs and wiring are in one spot for easy hookup and troubleshooting with only the coil, kill switch and headlight wires going up front along the frame and tailight wires to the rear if using them.The bracket is raw aluminum finish, use as is or paint/powdercoat desired color (may have some minor scratches, i do not polish them). It is shipped flat for ease of shipping and less chance of damage. Very easy to bend by hand or with any clamp/pliers. It mounts on the forward most of the rear plastics mounts with factory bolts (see pictures or our YouTube Video).Make sure you get a good ground to the bracket as the regulator depends on it, run an extra short ground wire if necessary.It will not work with the factory air box and lid (may work without lid, not verified). It comes with the holes properly located for the CDI and Regulator, as well as 4 zip tie holes (as seen in installed pic).Kit Includes CDI Relocation Bracket in raw aluminum 4 regular hex head bolts and nuts 4 small zip tiesDoes Not Include CDI & Regulator Wiring Stainless Bolts The Banshee or anything else not listed above!(I will no longer accept returns if you fail to read the description!)

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|