|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
UNO R3 Controller Board ATmega328P, Compatible with Arduino
$21.58

Product description ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 Controller Board ATmega328P, Compatible with Arduino IDE ELEGOO UNO R3 microcontroller board is based on the ATmega328P and CH340C, 100% compatible with Arduino UNO R3. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything you need to support your microcontroller, including dedicated SCL, SDA and IOREF pins; just connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started. The ATmega328P on the UNO R3 controller board is the same as the official Arduino UNO R3 board, and comes pre-programmed with a bootloader that allows you to upload new code to it without using an external hardware programmer. The ATmega328P has 32 KB (with 0.5 KB occupied by the bootloader). It also has 2 KB of SRAM and 1 KB of EEPROM (which can be read and written with the EEPROM library). The RX and TX LEDs on the board will flash when data is being transmitted via the USB-to-serial chip and USB connection to the computer. The ELEGOO UNO R3 puts SDA and SCL pins beside the AREF. Besides, there are two new pins placed near the RESET pin. One is the IOREF which allows the shields to adapt to the voltage provided by the board and the other one is reserved for future purposes. The ELEGOO UNO R3 works with all existing shields and can adapt to new shields that use these additional pins. - START CODING WITH A FLEXIBLE UNO R3 BOARD: Connect the included USB cable, upload sketches with Arduino IDE and build sensor, motor, display and automation projects for maker desks, classrooms, coding labs and electronics prototyping
- ATMEGA328P CORE FOR EVERYDAY PROJECTS: A 16 MHz clock, 32 KB flash, 2 KB SRAM, 1 KB EEPROM, 14 digital I/O pins with 6 PWM outputs and 6 analog inputs support LEDs, buttons, relays, servos, displays and sensors
- CH340C USB-TO-SERIAL INTERFACE: The onboard CH340C handles USB communication for sketch uploads and serial monitoring, while clearly labeled digital, analog and power headers help simplify wiring to modules and shields
- USB OR EXTERNAL POWER: Run the board from the included USB cable or a recommended 7-12 V external DC supply, then expand with compatible shields and modules for robotics, data logging, automation and custom embedded projects
- BOARD AND USB CABLE INCLUDED: Comes with 1 ELEGOO UNO R3 controller board and 1 USB-A to USB-B data cable; breadboard, jumper wires, sensors, shields and power adapter are not included

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|