|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
TM1637 0.36" 4-Digit RED LED Display Module for Arduino Clock Driver
$13.22

This module is a 12 pin 4-bit common anode digital tube (0.36 inches) display module with clock timing, and the driving chip is TM1637. Only 2 signal wires are needed to enable the microcontroller to control 4-bit 8-segment digital tubes. The display device is a 4-bit common positive red digital tube Digital tube with 8-level adjustable grayscale The control interface level can be 5V or 3.3V 4 M2 screw positioning holes for easy installation Product parameters: Control interface: There are a total of 4 pins (GND, VCC, DIO, CLK), with GND as the ground, VCC as the power supply, and DIO as the number According to the input and output pins, CLK is the clock signal pin; Digital tube: A 0.36-inch digital tube with a 4-bit common anode and a ratio point, highlighted in red; Positioning holes: 4 M2 screw positioning holes with a diameter of 2.2mm, making the module easy to install and locate, and achieving module to module combination

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|