Rode Videomic R On-Camera Shotgun Microphone *OPEN BOX*. Only open the box never took out of package or used. Brand new!
VideoMic is lightweight and when mounting on a camera it does not appear in the frame. The VideoMic can also mount to Rode\'s boompoles for elevated audio capture. Its super-cardioid polar pattern attenuates sounds from the sides. The result is a signal that sounds closer to the camera, even when shooting in noisy environments or at moderate distances.
The included Rycote Lyre is a non-elasticized suspension structure composed of a hard-wearing thermoplastic. It is more effective at acoustically decoupling microphones from unwanted vibrations, handling and cable-borne noise than elasticized suspensions. The lyre remains effective at a wide range of temperatures and is virtually indestructible. It will never wear out, sag, snap or require any rethreading to maintain its effectiveness.
An attached, coiled cable terminates to a 1/8\" (3.5mm) mini output connection. The VideoMic features a condenser element that utilizes standard 9 Volt batteries (sold separately). The microphone will run for approximately 100 hours on a single battery.
FEATURES
Barrel Canceling Pick Up: The Rode Video Mic functions as a true line plus gradient microphone with a super-cardioid pattern in the front and a barrel that cancels side-audio. The result is maximum pick up of the source in highly ambient and noisy environments
Selectable 10 or 20dB Pad: When capturing audio in loud environments, the VideoMic offers built-in attenuation. The selectable 10 or 20dB pad lessens the microphone\'s sensitivity, allowing it to handle higher SPL levels without sacrificing clarity
High Pass Filter Switch: A high-pass filter switch eliminates room ambiance and noise below 80Hz. This results in improved intelligibility while recording around machinery, wind or close proximities
Internal Power: The condenser element is powered with a standard 9-volt battery for up to 100 Condenser
Polar Pattern Super-cardioid
Frequency Response 40 Hz to 20 kHz
High-Pass Filter at 80 Hz, 12 dB/octave, selectable
Dynamic Range (Typical) 114 dB (per IEC651, IEC268-15)
Signal-to-Noise Ratio 74 dB (1 kHz at 1 Pa; per IEC651, IEC268-15)
Maximum Input Sound Level 134 dB (at 1% THD into 1kohm)
Power Requirements 9V battery
Output Impedance 200ohm
Output Connectors 1/8\" (3.5 mm) stereo mini plug, male
Pad -10 and -20 dB
Dimensions (½½ x H x L) 2.55x4.02x8.84\" / 65x102x250mm
Weight 6.21oz / 176g
WHO
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.