Product highlights
wired remote level control and clip lightworks with the following 2013-up Rockford Fosgate Punch amplifiers:
- P300X1, P400X1, P500X1bd, and P1000X1bd mono amps
- P300X2, P400X2, P500X2, and P1000X2 2-channel amps
- P600X4 4-channel amp
- P1000X5 5-channel amp
- 18\' remote cable and mounting hardware included
- dimensions: 1-7/16\"W x 1-1/4\"H x 1-5/8\"D (2-5/8\"D with knob and cable)
- warranty: 1 year
What\'s in the box
- 18\' remote cable with RJ-45 connectors on each end
- Mounting bracket
- Two 1/2\" Mounting screws
- LED with attached 8\" harness (used when mounting knob without its housing)
- Additional front panel
- Flat washer
- Nut
- Installation instructions
About this item
Written by Crutchfield\'s Buck Pomerantz
Control and monitor your amp\'s signal from the front seat
Rockford Fosgate\'s PLC2 wired remote allows you to control the volume of your Punch amp that\'s equipped with the C.L.E.A.N. (Calibrated Level Eliminates Audible Noise) setup system. From the driver\'s seat, you\'ll be able to adjust the amp\'s output level and monitor its incoming signal for distortion.
After using C.L.E.A.N. technology to set your amp\'s gain, just keep an eye on the PLC2\'s light. It\'ll turn red when the musical source is distorting, warning you to turn the receiver\'s volume down before your speakers or subwoofer suffer any damage.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.