Free Userbar - Userbars - User Bar - User Bars
 
Advanced search
Registered users

Username:

Password:

Log me on automatically next visit?

¬ Forgot password
¬ Registration

» Upload Userbar
» Animate Userbar
» Userbars Tutorial
» Userbar Tournaments
» Forum
» Chat Room
» FAQ
» Links

• PC Cheat Codes

>> If you dont know how to design a userbar, then write here a Userbar that you want. >> If you know how to design them help these people and design what they request.




USERBARS.org | Free Forum Userbars

On eBay now
eBay

Phase Linear 700 (all versions) Unobtanium Power Switch Upgrade

Phase  Linear 700 (all versions) Unobtanium Power Switch Upgrade
$39.00

Buy Now

The Phase Linear 700/700B/700II power switches were undersized and are failure prone. Replacements are scarce and expensive. During development of this solidstate switch, inrush currents exceeding 140 amps were recorded. It\'s no wonder that the switch doesn\'t hold up.
See the photo of inrush current. Yellow is the current. Blue is the AC input voltage. Notice how the voltage collapses during the first few cycles due to the high current demand. The amplifier under test was only 10 feet form the circuit breaker panel! The high voltage transformer feeding the house is only 50 feet away!!
This switch upgrade uses a 40 amp solidstate switch (triac) to do the heavy lifting. The existing switch controls the triac and only carries milliamps of current.
If the triac is only rated for 40 amps how can it withstand the high inrush current? Unlike transistors, SCR\'s, diodes and triacs can withstand short duration, high inrush currents without damage. The triac used here can withstand surge currents up to 400 amps.
Just like our Phase Linear relay boards, the triac board is installed without any drilling. It is held in place, beneath the main control board, by the lower mounting screw for the board. Spacers are used to maintain proper support for the main board. The aluminum chassis serves as a heatsink for the triac. The triac has an electrcially isolated mounting base to avoid shock hazard.
The kit comes with the board assembled and tested.
Installation is simple. Remove the power wires from the switch and land them on the board. Add two 18 gauge wires from the original switch to the board and you\'re done. Cost includes all hardware, wire and ty-wraps for a neat installation.Detailed instructions are supplied.

Buy Now

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Related Userbars
       

More items on eBay

As an eBay Partner, userbars.org may earn a commission from qualifying purchases.



All userbars are property of respective authors.
Copyright © 2002 4homepages.de | Template © 2005 Bali Web Design