exact item shown,older unit, shows wear, works as it should, see test data. to adjust coupling, loosen the two Allen screws and rotate the coupled port connector assembly. Inside is a resistor that is soldered to ground where you see the dot and then the other end is wired via a straight wire to the center terminal of the N coupled connector. I opened this up because I couldn\'t undersand what it was doing, so that I post is from that observation. sadly I didn\'t take a photo, inside there is a straight line from the input to output (through) connectors and the loop with a resistor I described. I tested this one on a 3 GHz analyzer, as you can see in the photos.
from the data sheet Coupler (CE & CF): Microlab loop couplers consist of a directional loop loosely coupled to a main transmission line. One end of the loop is connected to a built in terminating resistor mounted in a carefully matched housing. Users may wish to compensate for the inherent 6 dB per octave coupling variation of the loop with an external network. These devices are primarily used for loosely coupled applications (30 dB or more) and for frequencies under 4 GHz.
Note to me: computer hutch bin 1
I normally ship within 24hours of your order, but the post office does not alwaysinitiate tracking when Iput the packages in the drop off box.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.