50 games total no duplicates console in box, voice module in box with manual.. Power cord attached. Rca cord, Most boxed games are complete There are games like donkey Kong and frogger that never came with overlays so there aren\'t any included so they are not missing Only a few incomplete boxed games for instance Loco motion is short 1 overlay mr bits and basic is missing a cartridge. d&d and backgammon have no overlays. There are some games as shown that are cart only as shown Some games i had to reinsert a few times until they loaded which is the same as I remember. Most boxes are good . 4 are very worn (donkey Kong triple action mr buts and basic and Burger Time, and commando which is quite worn with torn flap a few not mamy overlays have extra wear wear. A few with sticker wear on some of the carts as well A few manuals with extra wear not many. Everything has been Tested and is working as shown. Voice module with box. All cords included but no Switch box is included. Console box has wear as well. Aging etc.
*** Hooking up the console to your television. For many all you may need is a shielded RCA Video cable and a good game switch box (a good one) Many people use F-Type Coaxial to RCA Female Adapter: This small connector screws onto the TV\'s coaxial/antenna port, allowing the RCA cable to plug right into a modern screw-on antenna jack, but you may have interference which causes a snowy image Also a game switch box in poor condition can cause static or snowy picture, (other options below such as using a vcr) You will need to get your TV to scan for channels on the live tv option and by scanning \"antenna\" while the system is on with a game in it you may have to do this a couple of times in case the game didn\'t correctly load the first time or 2nd to get your TV to pick up the signal
RF Output: The console uses an analog RF signal through a switchbox or an RCA-to-coaxial adapter.Channel Switch: A physical switch on the back or bottom of the console lets you choose between channel 3 and channel 4.Modern TVs: If you connect it to a modern TV with a coaxial jack, you must manually run an analog channel auto-scan, or use an old VCR as a signal pass-through, because many flat-screen TVs do not automatically detect weak analog RF signals.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.