MSD 6425 Digital 6AL Ignition Control Box w/ Rev Control & 8732 2-Step COMBO Kit

MSD 6425 Digital 6AL Ignition Control Box w/ Rev Control & 8732 2-Step COMBO KitFeatures:

• Higher output with 530 primary volts and 135mJ of spark energy
• Efficient components use less current to produce more power
• Set an rpm limit on the 6AL with two rotary dials in 100 rpm increments
• Same bolt pattern as the original 6AL with a lower profile housing
• Built-in LED for system checks
• All wires exit through a locked, sealed connector
• Compatible for 4, 6 or 8-cylinder engines

The MSD 6AL Ignition Control set the standards that other ignitions strive to reach. In fact, you’ll find ignitions from other companies that carry the 6AL name (and in some cases, the same part number). For 2011, the bar has been raised even higher as we introduce the all new Digital 6AL Ignition Control!MSD started with a clean slate and drew up plans for an all new housing. We kept the same footprint as the traditional 6AL but lowered the profile for a sleek look. The wiring is all routed out one end of the unit through a sealed and locking connector. This eases installation and keeps your wiring looking neat and clean. The rev limiter was moved right on top of the housing for easy access to the two rotary dials to set the limit in 100 rpm increments.Inside the Digital 6AL you’ll find a microprocessor that monitors and controls every firing and rev limit. The circuits are updated with efficient components that help the ignition produce more power while drawing less current! In fact, the new Digital 6AL delivers over 530 volts to the coil with up to 135mJ of spark energy for every firing! Increased output combined with MSD’s proven multiple spark series is a win-win situation!The new Digital 6AL are supplied with the wiring harness and the components you’ll need for installation. The 6AL is also supplied with vibration mounts. Both ignitions are compatible on 4, 6 or 8-cylinder engines with 12-volt, negative ground electrical systems. They’ll accept trigger inputs from breaker points, amplifiers and magnetic pickups.
MSD 8732 MSD Ignition Black Digital 2-Step Rev Controllers Multi-Step RPM
MSD\'s 2-Step Rev Control allows racers to switch to a low rpm limit at the starting line. This digitally-controlled 2-Step Controller connects to the Digital 6AL\'s gray tach output wire and has (2) rotary dials that let you set the launch rpm in 100 rpm increments. An activation wire connects to the transbrake, a clutch switch or to the line-lock to activate the low rpm limit. When releasing the switch, the low rpm limit is turned off and the car launches hard.Features:

• The rpm limit is set with the (2) rotary dials, in 100 rpm increments

For Digital 6AL Box only # 6425