Kitchen Aid Stand Mixer Factory Identical Replacement Capacitor OEM
$19.99

This listing is for the speed control capacitor that was used on the pre-1976/78 KitchenAid stand mixers. It is no longer supported by KitchenAid and can be difficult to find. Fortunately, I can offer them to the person who isn\'t afraid to fix their own appliances. I repaired mine when the original capacitor blew about 10 years ago and it\'s worked perfectly ever since. If your mixer speed cannot be controlled and will only run at full speed, odds are this is the part you\'ll need to replace. Simply remove the rear, vented cover and you\'ll see the capacitor inside of a cardboard sleeve. If it\'s shot it will be discolored or appear burned. If it is, then this is the part you\'ll need. Depending on your specific model, you may need to lengthen the leads of the cap by soldering on additional wiring which is not included. The leads on this replacement capacitor are not insulated so you\'ll want to give them a wrap during reassembly. The leads are not polarity sensitive. PLEASE REMEMBER: This is not for modern production, solid state (post 1976/78) KitchenAid stand mixers. If your mixer electronics are not similar to the photo shown above, this may not be the correct part for you. The capacitor is inside of the cardboard sleeve which is clearly visible at the top of the photo. This component is configured for 110VAC, 60 cycle electrical source. These capacitors are brand new and identical in performance and design specs as the original, factory supplied capacitors. They are not salvaged from other mixers and they have never been installed. I\'ve sold over 250 of these capacitors and have not had a single complaint. They work! Item will be shipped USPS Ground in a 6\" x 4\" rigid cardboard mailer.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.