|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
In Tank Check Valve 1/2" Compression Top Inlet, 1/2" Male NPT Bottom Outlet
$19.95

Made in the USA
UPE GroupIn Tank Check Valve for Air Compressors, USA Made All Brass Construction, 1/2\" Compression Top Inlet, 1/2\" Male NPT Bottom Outlet - 1/2\" Compression Tube Top Inlet, 1/2\" Male NPT Bottom Outlet To Receiver Tank, Made In The USA
- Compressor Pump Discharge Connection: 1/2\" OD (Outside Diameter) Copper or Aluminum Tubing
- Outlet Connection to Receiver Tank: 1/2\" Male NPT, 500 PSI Max, 20 CFM Flow Rate, -65° to 450°F, Reinforced PTFE Seal
- Compression Nut and Ferrule Included, Optional 1/8\" Male NPT Unloader Plug Included
- Proudly Made in the USA
UPE Group Ctl-series Check Valves Are Used In Compressed Gas And Pneumatic Systems. Check Valves Have Two Ports And Restrict The Flow Of Fluids And Other Loose Materials Through A Pipe Or Passageway To One Direction. These Valves Open To Allow Flow In One Direction And Close When The Flow Stops Or Reverses. The Ct-series And Ctl-series Have A Male Outlet Connection For Use In Tanks And Receivers. This UPE Group In-tank Check Valve Is A Poppet-type Valve, And May Be Disassembled For Servicing And Repair. The Valve Body Is Made Of Brass For Corrosion Resistance, Ductility At High Temperatures, And Low Magnetic Permeability. Brass Can Be Connected To Copper, Brass, Plastic, Aluminum, And Welded Steel. This Valve Has A Reinforced Polytetrafluoroethylene (Ptfe) Poppet With Eight Discharge Holes For Quiet Operation, And Stainless Steel Spring. The Maximum Pressure Rating Is 500 Pounds Per Square Inch (Psi), And The Maximum Working Temperature Is 450 Degrees Fahrenheit. Check Valves Are Rated By Their Cracking Pressure (The Minimum Upstream Pressure Required For The Valve To Operate), And They Are Used In Various Water, Gas, Air, And Steam Lines. We Include Compression Nut And Ferrule.Optional 1/8\" Male Npt Unloader Plug also Included. Materials Of Construction: Body: Brass Valve Housing: Brass Seal: Reinforced Ptfe Spring: 302 Stainless Steel
IMPORTANT: DO NOT CALCULATE YOUR MEASUREMENT WITH A TAPE MEASURE OR RULER. CHECK VALVES FOLLOW THE NPT (NATIONAL PIPE THREAD) GUIDELINES AND CANNOT BE MEASURED WITH A LINEAR TOOL. IF YOUR ONLY UNIT OF MEASUREMENT IS A TAPE MEASURE OR RULER. PLEASE CLICK THIS LINK BELOW TO GET THE CORRECT PIPE THREAD MEASUREMENT USING A LINEAR MEASURING TOOL.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|