Please read before buying.
Check my other listings as I have blue, red, gold and 3D Violet (very close to HPI color).
Confirmed fitness is HPI Super Nitro RS4. May fit other HPI model, please do your research before buying.
All custom parts are made by me in the USA.
This is a custom set for HPI A430-A, A430-B, A430-E and A470-6.
Only 30 sets made(between all colors) and I’m keeping 2 sets. Cost is too high to make again.. Need $400 to pull even with machine time.
Changes made to this set vs stock plastic parts.
Inside gear mesh is tighter. All gear move to the center by .1mm. Pulley off center was moved from 4.5mm to 4.75mm to match 18T pulley and dead center to the front upper arm mount (A411-7). Bearing housing A470-6 moved the bearing out by .15mm each side towards the 39T pulley. So much play before and it keeps the pulley from rubbing the rear bulkhead.
Set includes:
2x custom Aluminum 6061 parts (A430-A)
2x custom Aluminum 6061 parts (A430-B)
2x custom Aluminum 6061 parts (A470-6)
4x custom Aluminum Bronze parts (A430-E)
4x custom Aluminum Bronze parts (bushings for shaft)
2x custom lower differential lockers
2x custom upper differential lockers
4x 3mm x 13mm hardened steel dowel pins ((installed)
10x M2 X 12mm A2 18-8 Stainless Countersunk screw
2x 3mm x 22mm hardened steel dowel pins
4x 3mm x 7mm x .2mm stainless shims (place behind A850b)
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.