Electronic Engine Speed Controller Unit Governor Generator ESD5500E for GAC

Applications:
Fit For GAC matched actuators (not for ACB2000 electronic actuators)

Specifications:
Easy to install
High anti-interference and non-interference with other control devices
Actuator short-circuit protection
Anti-reverse battery protection,
Anstantaneous voltage and lost speed signal safety protection
Operating temperature range: -20 ℃ ～ + 85 ℃
Relative humidity: 95%
Vertical signal: 0.5-120V RMS
Output current: 0-10A DC square wave (continuous)
Speed Trim Range: ± 200HZ 5K potentiometer
Input Power Supply: 12 or 24V DC
Connector:
A-B: Actuator
C-D: Speed ​​sensor
E-F: Battery
G-J: Trimmer potentiometer
G-M: Idle switch
K-L: Speed control
Isochronous Operation/Steady State Stability: ± 0.25% or better
Speed Range/Governor: 1K-7.5K Hz continuous
Speed Drift with Temperature: ± 1% Maximun
IDLE Adjustment: 160 ± 20Hz ~ 60% of set speed
Droop adjustment Min.(K-L Jumpered): 15Hz. ± 6Hz. per 1.0 A change
Droop adjustment Max.(K-L Jumpered): 400Hz. ± 75Hz. per 1.0 A change
Droop Adj. Max. (K-L Jumpered): 875Hz., ± 75Hz. per 1.0 A change
Droop Adj. Min. (K-L Jumpered): 15Hz., ± 6Hz. per 1.0 A change
Remote Variable Speed Range: 500 -7.5Hz. or any part thereof
Terminal Sensitivity:
J: 100Hz., ± 15Hz/Volt at 5.0 K Impedance
L: 735Hz., ± 60Hz/Volt at 65 K Impedance
N: 148Hz., ± 10Hz/Volt at 1Meg. Impedance
P: 10V DC Supply at 20ma Max.
Speed Switch Adjustment Range: 1000-10000Hz.
Storage Temperature: -55°c ~ 90°c
Shock: 20-100HZ 500mm/Sec.
Polarity: Negative Ground(Case Isolated)
Power Consumption: 50mA continuous plus actuator current
Actuator Current Range at 25°c-(Inductive Load) : Min. 2.5 Amps, Max. 10 Amps continuous
Speed Switch Relay Contacts(N.O.and N.C.): 10Amp