|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
Battery Replacement KIT For Hayward AQL2-POD AquaPod Wireless Remote Control
$47.99

660MAHBattery Replacement For Hayward AQL2-POD AquaPod Wireless Remote Control KITWith Built in overcharge circuitry . Battery has bare ends, you can use your old existing plug connector and included heat shrink tubesPlease note: Installing battery means you must pry open the waterproof seal on the remote to access and replace the old battery and reinstall. SIMPLY CUT AND REATTECH YOUR OLD CONNECTOR and use the included heat shrink tubes. Please do not purchased Unless you are aware you need to pry open the old remote casing to replace the battery. Please note, as with any DIY project do so at your own risk. KIT includes: - Replacement 650MAH 3.7V Battery
- Heat shrink tubes (simply connect old wiring terminal)
- Lil’ Chizler stiff pry/separtion device removes to remove old trim to separate remote
- Double sided Foam tape (Replacement needed that attaches new battery
- 2 pack small alcohol pads (to remove old battery adhesive

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|