Compatibility:2007-2009 Dodge Sprinter 2500 3.0L2007-2008 Dodge Sprinter 2500 3.5L2007-2009 Dodge Sprinter 3500 3.0L2007-2008 Dodge Sprinter 3500 3.5L2014 Freightliner Sprinter 2500 2.1L2007-2014 Freightliner Sprinter 2500 3.0L2007-2008 Freightliner Sprinter 2500 3.5L2014 Freightliner Sprinter 3500 2.1L2007-2014 Freightliner Sprinter 3500 3.0L2007-2008 Freightliner Sprinter 3500 3.5L2010-2013 Mercedes-Benz Sprinter 2500 3.0L2010-2013 Mercedes-Benz Sprinter 3500 3.0LFeatures:-OE design to ensure exact fit, form and function for an easy drop-in installation;-Built with high density multi-lowered fins for maximum cooling efficiency; Aluminum Radiator For 07-09 Dodge Sprinter 10-13 Mercedes-Benz Sprinter 2500
Compatibility:
2007-2009 Dodge Sprinter 2500 3.0L2007-2008 Dodge Sprinter 2500 3.5L2007-2009 Dodge Sprinter 3500 3.0L2007-2008 Dodge Sprinter 3500 3.5L2014 Freightliner Sprinter 2500 2.1L2007-2014 Freightliner Sprinter 2500 3.0L2007-2008 Freightliner Sprinter 2500 3.5L2014 Freightliner Sprinter 3500 2.1L2007-2014 Freightliner Sprinter 3500 3.0L2007-2008 Freightliner Sprinter 3500 3.5L2010-2013 Mercedes-Benz Sprinter 2500 3.0L2010-2013 Mercedes-Benz Sprinter 3500 3.0L
Features:
-OE design to ensure exact fit, form and function for an easy drop-in installation;
-Built with high density multi-lowered fins for maximum cooling efficiency;
-ISO 9001 certified manufacturing plants;
-Direct Replacement;
-Improve Cooling Efficiency;
-100% Leak Tested;
-Plastic tanks with aluminum core;
-Built to strict quality control standards;
How to clean radiator:
1.Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake fromthetank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2.After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1.Disconnect the battery.
2.Drain the radiator fluid into a suitable container.
3.Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4.Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5.Fill the radiator with fluid.
6.Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the operation, the vehicle normal temperature 60 to 80 degrees.
2.Add detergent if the tank is too full can take some brand new radiator
Item SpecificsBrand ECCPPManufacturer Part Number E164579CPWarranty 1 YearInterchange Part Number CU13254,Engine Rad,Replacement Radiator,1.03in.Core ThicknessCustom Bundle NoModified Item NoFitment Type Direct ReplacementPlacement on Vehicle FrontType RadiatorMaterial AluminumCore Material AluminumTank Material PlasticQuantity 1PC RadiatorCore Length 26.7in.Core Height 15.67in.Core Thickness 1.03in.Inlet Diameter 1 3/8in.Outlet Diameter 1 7/8in.Other Part Number RAD13254,engine radiator,cooling radiator,air radiator,aluminiumSuperseded Part Number DPI13254,AC13254,RAD13254Radiator Cap As Picture showsStyle CrossflowRow Count 1 RowColor Black or SilverNotes Please verify the item fits your vehicle or not by compatibility Item SpecificsBrand ECCPPManufacturer Part Number E164579CPWarranty 1 YearInterchange Part Number CU13254,Engine Rad,Replacement Radiator,1.03in.Core ThicknessCustom Bundle NoModified Item NoFitment Type Direct ReplacementPlacement on Vehicle FrontType RadiatorMaterial AluminumCore Material AluminumTank Material PlasticQuantity 1PC RadiatorCore Length 26.7in.Core Height 15.67in.Core Thickness 1.03in.Inlet Diameter 1 3/8in.Outlet Diameter 1 7/8in.Other Part Number RAD13254,engine radiator,cooling radiator,air radiator,aluminiumSuperseded Part Number DPI13254,AC13254,RAD13254Radiator Cap As Picture showsStyle CrossflowRow Count 1 RowColor Black or SilverNotes Please verify the item fits your vehicle or not by compatibility
PictureHot Item ECCPP 2x Front Hood Lift Supports Struts Springs For Dodge Ram 2002-2010 4364 USD 16.89 Pair Manual Tow Mirrors for 1988-1998 Chevy GMC C/K 1500 2500 3500 Side Mirrors USD 77.48 Front Wheel Hub Bearing Assembly For Chevy Impala Cadillac DTS Buick Lucerne FWD USD 43.37 2 Pcs Front Wheel Hub Bearings For Chevy Impala Buick Regal Lucerne LeSabre FWD USD 61.95 Pair Tow Mirrors For 2007-2014 Chevy Silverado Sierra Power Heated LED Signal USD 141.92 Shop CategoryStore Home Air Dryer Anti Snow Chains Brake Dust Shield Car Tools◈Car Tools◈Electric Winch Tow◈Jack Stand◈Jumper Cable Catalytic Converter Chainsaw Chain Cooling System◈AC Compressor◈AC Compressor Hose◈AC Compressor Pulley◈Air Blend Door Actuator◈Blower Motor Resistor◈Condenser◈Coolant Tank◈Cooling Fan◈Evaporator◈Heater Shutter◈Radiator Support◈Thermostat Housing◈Water Pump◈Water Pump Impeller Copper Tube◈Brake caliper◈Brake drum shoe◈Brake rotor pad◈Brake Shoe◈Power Brake Booster Crankshaft And Camshaft◈Camshaft & Crankshaft◈Harmonic Banlancer Drive Belt And Device◈Primary Drive Clutch◈Serpentine Belt Tensioner Drive Shaft And Half Shaft◈4 Pcs Wheel Hub Bearing◈ATV/UTV CV Axles & Parts◈CV Axle◈CV Axle Boot◈Driveshaft◈Rear Wheel Axle◈Wheel Hub Bearing◈Wheel Hub Bearing Knuckle◈Wheel Hub Centric Rings◈Wheel Spacers Engine Bracket Glue◈Engine Mount Engine Gasket & Cylinder Head◈Cylinder Piston Gasket Kit◈Head Gasket Set Engine mount Fuel System◈Fuel Injectors◈Fuel Pump Assembly◈Fuel Tank Pipe & Cap◈Mass Air Flow Sensor◈Motorcycle Carburetor & Parts Fuel Tank Fuel Tank Mounting Straps Fuel Vapor Charcoal Canister◈Vapor Canister Garden Water Pump Gas Distribution System◈Hydraulic Lifter & Rocker Arms◈Idle Air Control Valve◈Secondary Air Pump◈Throttle Body◈Turbocharger◈Valve CoverNew List Item Front Right For Ford Taurus 2.0L 2013-2017 FWD CV Axle Assembly USD 105.99 Front Right for Mini Cooper Clubman 2.0L 2017-2019 31608611938 CV Axle Assembly USD 59.09 Front Right For Nissan Versa 1.6L 2012 CV Axle Assembly 39100EL005 USD 70.99 Front Right For Mitsubishi Outlander PHEV 2.4L 2021-2022 CV Axle Assembly USD 82.99 Front Right for Toyota Venza 2009-2015 V6 3.5L AWD CV Axle Assembly USD 77.99 Aluminum Radiator For 07-09 Dodge Sprinter 10-13 Mercedes-Benz Sprinter 2500 Compatibility:
2007-2009 Dodge Sprinter 2500 3.0L2007-2008 Dodge Sprinter 2500 3.5L2007-2009 Dodge Sprinter 3500 3.0L2007-2008 Dodge Sprinter 3500 3.5L2014 Freightliner Sprinter 2500 2.1L2007-2014 Freightliner Sprinter 2500 3.0L2007-2008 Freightliner Sprinter 2500 3.5L2014 Freightliner Sprinter 3500 2.1L2007-2014 Freightliner Sprinter 3500 3.0L2007-2008 Freightliner Sprinter 3500 3.5L2010-2013 Mercedes-Benz Sprinter 2500 3.0L2010-2013 Mercedes-Benz Sprinter 3500 3.0L
Features:
-OE design to ensure exact fit, form and function for an easy drop-in installation;
-Built with high density multi-lowered fins for maximum cooling efficiency;
-ISO 9001 certified manufacturing plants;
-Direct Replacement;
-Improve Cooling Efficiency;
-100% Leak Tested;
-Plastic tanks with aluminum core;
-Built to strict quality control standards;
How to clean radiator:
1.Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake fromthetank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2.After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1.Disconnect the battery.
2.Drain the radiator fluid into a suitable container.
3.Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4.Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5.Fill the radiator with fluid.
6.Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the operation, the vehicle normal temperature 60 to 80 degrees.
2.Add detergent if the tank is too full can take some brand new radiator
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.