Aluminum Competition Holster for Ruger RXM with Streamlight TLR-7X
This is the Pro Heavy Duty Competition Holster from Black Scorpion Outdoor Gear: a 0.08 in Kydex shell on an anodized aluminum belt attachment, for USPSA, IPSC and 3 Gun. A 15 mm spacer built into the attachment holds the pistol at 90 degrees to the ground, so the grip sits in the same place on every draw.
Fits
Ruger RXM using the Streamlight TLR-7X with UNIV-1 key
Molded for the model above only. If your pistol has a light, thumb rest or optic plate that is not named here, it takes a different holster. Not sure? Message us before you buy.
Pick your colors
The Color menu is the belt attachment color first, then the holster color. Example: \"Red / Carbon Fiber\" is a red aluminum attachment with a carbon fiber holster. Each choice shows its own photo.
Where it is legal
USPSA: yes. It stays inside the 2 1/8 in limit from the belt to the grip, the tightest limit in USPSA (Carry Optics, Production and Single Stack), so it clears every division. Keep the heel of the grip above the belt (rule 5.2.11).
IPSC: yes. It stays inside the 50 mm limit from the outer face of the belt to the center of the grip (5.2.5), which applies in every IPSC division.
IDPA: no. IDPA bars race gear (8.1). Shooting IDPA? This is the wrong holster.
How it adjusts
Ride height and angle both adjust with two 3 mm Allen screws on the back of the belt attachment. Retention is set by hand with two thumb screws on the shell: tighten them for more hold, back them off for a lighter draw. The front of the shell is cut low to clear a slide-mounted optic.
Setting it up
- Put it on your belt. The attachment fits 1.5 in competition belts only. On the back of the attachment are two metal tabs. Loosen them with a Phillips screwdriver to open the slot wider, then slide the attachment onto your belt or place it over the belt, and tighten the tabs.
- Set ride height and angle. With an unloaded pistol, loosen the two 3 mm Allen screws on the back of the attachment, set the height and angle, and tighten them again.
- Set the retention. Turn the two thumb screws on the shell by hand until the draw feels right.
- Lock the screws. Once everything is where you want it, put a drop of removable (blue, medium strength) thread locker on the tab screws and the Allen screws. Do not use permanent (red) thread locker. It can seize the screws so they won\'t come out. Check every screw before you shoot.
CarryOutside the waistband, competition holsterLegal inUSPSA (all divisions) and IPSC. Not IDPA.HandRightBelt attachmentAnodized aluminum in black, red or blue, with a built-in 15 mm thigh spacerHolster colorBlack or carbon fiberShell0.08 in thermoformed KydexOpticsLow cut for slide-mounted opticsBelt1.5 in competition belts onlyAdjustsRide height and angle (two 3 mm Allen screws)RetentionTwo thumb screws, set by handToolsPhillips screwdriver, 3 mm Allen keyMade byBlack Scorpion Outdoor Gear, Sunrise, Florida
Pistol not included. The Grunt Club is an authorized Black Scorpion Outdoor Gear retailer. If you\'re putting in the work, you\'re in the club.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.