Part Number:
DSE703
Applications:
Compatible with Deep Sea ATS
Introduction:
The DSE703 is an Auto Transfer Switch Control Module that has been designed to monitor the mains (utility) supply.When the mains (utility) power fails the module sends a start request to the generator control unit. When the generator is up and running the module transfers the load across. When the mains (utility) returns the module transfers the load back and removes the start command.
The generator should then begin it’s shutdown procedure.The module can be configured so that they follow the users pre-set start and stop sequences.
The module has been designed to monitor over speed, under speed, high engine temperature, low oil pressure, battery charge fail and
fail to start.
The module also has two configurable auxiliary inputs and a configurable engine pre-heat timer. When the module detects a fault condition it automatically shuts down the engine, indicating the exact fault via LED.
Features:
Manual start
Automatic start
Engine pre-heat
Engine monitoring and protection features
Protected Solid State (PSS) outputs
Front panel mounting
Front panel programming
Tamper proof engine hours counter
Remote start
LED indicators
Configurable inputs
Configurable timers
Configurable outputs
Engine exercise mode
Single/three phase mains sensing
On Jun 22, 2025 at 18:21:13 PDT, seller added the following information:
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.