ALL-CARB DC10K Diesel Generator Manual Start Controller Module Genset Controller

Caution:Minor differences in product design may result in different model numbers.Please check the picture carefully to see if it matches your product.If you are not sure if this model is right for you, please feel free to contact us.

Features:

ALL-CARB DC10K Diesel Generator Manual Start Controller Module Genset Controller

Caution:
Minor differences in product design may result in different model numbers.
Please check the picture carefully to see if it matches your product.
If you are not sure if this model is right for you, please feel free to contact DC10K is designed as one of the engine manual start controller.
The Hz, Volt, Battery voltage and accumulation time can be displayed through the front face LED screen. This controller is also with various kinds of stop and alarm indications to monitor the genset status. Besides, it can also connect with PC so that parameters can be set through Computer to equip for more different gensets.
Operation:
1. Power On: Switch “0” to “I” till the tube is lighted, In the procession of cranking, over speed indicator will be lighted if the crank is not successful after 45sec. (controller will cut off fuel solenoid’s output and come into protection)
2. Start Running: Switch “I” to “II” till engine started. Once power on the engine, it will be cranked. the controller will come into running status after 8 sec if cranking successfully. Then the controller will monitor the relative parameters and set protection. (the controller will cut off fuel solenoid output and display the alarm status if the genset is stopped.) Please Switch from “I” to “0”.
3. Stop and Reset: Switch from “I” to “0” and take off the power.
Comparison of DC10G & DC10K:
Similar functions, but with different wiring.

Please connect the module to PC by communication cables and powered on.
1. Alarm Setting:
* Over speed alarm: 1710RPM (Rated 50Hz), 2040RPM (Rated 60Hz), range: 0-4000RPM, when the RPM is over this value and keep more than 1sec, then the controller will alarm and stop.
* Over frequency alarm: 57Hz (Rated 50Hz), 68Hz (Rated 60Hz), range: 40-80Hz, when the frequency is over this value and keep more than 1 sec, then the controller will alarm and stop.
* Low frequency alarm: 20Hz, range: 20-60Hz, when the frequency is lower than the value and keep more than 5sec, the controller will alarm and stop.
* Over voltage alarm: 265V, range: 50-500v, 500V is set as forofferden. When the voltage is over this value and keep more than 5sec, then the controller will alarm and stop.
* Charging failure D- value: 6V, range: 1-24V, when the different value between charging D+ and Battery B+ is over this value and keep more than 5sec, then the controller will alarm.

2. Display Setting:
* Four Screen self-cycling display: the parameters shall be switched timely according to the interval time setting after choosing this option.
* Homepage option: one parameter can be displayed as homepage display after choosing this function. The page will be switched automatically after pressing page change button for a while.
* Revert-back delay: the time to revert back to homepage.
* Self-cycling display time: the interval time setting.

Type: Genset Controller
Speed input: Freq 300Hz～10kHz
Hole size: 67 × 67mm/2.6 × 2.6"
Power consumption: MAX. 2W
Model: DC10K
Power supply input: 8-33VDC
Power generation input: 15-300VAC, 50/60Hz
Dimensions: 78 × 78 × 72mm/3.1 × 3.1 × 2.8"
Oil valve output: MAX. 16A
Motor output: MAX. 10A
Excitation output: MAX. 80mA
Alarm output: MAX. 16A
Working temperature: -30 to 75℃/-86℉ to 167℉
Storage temperature: -40 to 85℃/-104℉ to 185℉
Product weight: 280g/0.6LB
This product offers the best after-sales service.
We are committed to providing you with durable and high quality products.
Thank you for choosing our products!

Includes:

1 × DC10K Genset Controller Generator Controller Engine
Item SpecificsCountry of Origin United StatesBrand ALL-CARBMPN MOT4666332Speed input Freq 300Hz～10kHzType Genset ControllerWarranty 1YearPower consumption MAX. 2WModel DC10KCustom Bundle NoBundle Description NoModified Item NoPower supply input 8-33VDCColor BlackDimensions 78 × 78 × 72mm/3.1 × 3.1 × 2.8"Hole size 67 × 67mm/2.6 × 2.6"Power generation input 15-300VAC, 50/60HzOil valve output MAX. 16AMotor output MAX. 10AExcitation output MAX. 80mAAlarm output MAX. 16AWorking temperature -30 to 75℃/-86℉ to 167℉Storage temperature -40 to 85℃/-104℉ to 185℉Product weight 280g/0.6LB
Payment We accept Paypal,Google Pay,VISA,Master Card,American Express.Discovere, Mastercard payment.Shipping Notice: The Guaranteed Date is automatically generated and displayed by . We can't change it and can't control the speed of delivery, it's depend on the carrier. We will ship your item out asap after the payment is clear.Usually your Items will be shipped within 1-3 business day after your payment is cleared.International orders may take 10 to 30 business days to arrive.We have CA, NJ warehouses and ship items may vary according to the stock.Returns Please contact us first when return, exchange and refund is required.Any direct return of purchased items will not be processed.Change-of-mind return can only be accepted within 7 days after purchase.All other returns can be accepted in 30 days.We will closely examine the condition of the returned items and will not issue any refund/exchange before we make sure the items are in their original neat conditions.Contact Us And our office is closed on Sunday and we apologize for the late reply during the holidays.Before leaving us neutral or negative response, please contact us first.We will do everything we can to give you a satisfying solution.Please don't open case via or PayPal.We do our best to resolve any issue. Leaving negative response and low ratings doesn't get things solved.So please talk with us and we will not let you down.response

We strive for 100% customer satisfaction! response IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative response, so that we can satisfactorily address your concerns.

Carburetor ALL-CARB DC10K Diesel Generator Manual Start Controller Module Genset Controller

Caution:
Minor differences in product design may result in different model numbers.
Please check the picture carefully to see if it matches your product.
If you are not sure if this model is right for you, please feel free to contact DC10K is designed as one of the engine manual start controller.
The Hz, Volt, Battery voltage and accumulation time can be displayed through the front face LED screen. This controller is also with various kinds of stop and alarm indications to monitor the genset status. Besides, it can also connect with PC so that parameters can be set through Computer to equip for more different gensets.
Operation:
1. Power On: Switch “0” to “I” till the tube is lighted, In the procession of cranking, over speed indicator will be lighted if the crank is not successful after 45sec. (controller will cut off fuel solenoid’s output and come into protection)
2. Start Running: Switch “I” to “II” till engine started. Once power on the engine, it will be cranked. the controller will come into running status after 8 sec if cranking successfully. Then the controller will monitor the relative parameters and set protection. (the controller will cut off fuel solenoid output and display the alarm status if the genset is stopped.) Please Switch from “I” to “0”.
3. Stop and Reset: Switch from “I” to “0” and take off the power.
Comparison of DC10G & DC10K:
Similar functions, but with different wiring.

Please connect the module to PC by communication cables and powered on.
1. Alarm Setting:
* Over speed alarm: 1710RPM (Rated 50Hz), 2040RPM (Rated 60Hz), range: 0-4000RPM, when the RPM is over this value and keep more than 1sec, then the controller will alarm and stop.
* Over frequency alarm: 57Hz (Rated 50Hz), 68Hz (Rated 60Hz), range: 40-80Hz, when the frequency is over this value and keep more than 1 sec, then the controller will alarm and stop.
* Low frequency alarm: 20Hz, range: 20-60Hz, when the frequency is lower than the value and keep more than 5sec, the controller will alarm and stop.
* Over voltage alarm: 265V, range: 50-500v, 500V is set as forofferden. When the voltage is over this value and keep more than 5sec, then the controller will alarm and stop.
* Charging failure D- value: 6V, range: 1-24V, when the different value between charging D+ and Battery B+ is over this value and keep more than 5sec, then the controller will alarm.

2. Display Setting:
* Four Screen self-cycling display: the parameters shall be switched timely according to the interval time setting after choosing this option.
* Homepage option: one parameter can be displayed as homepage display after choosing this function. The page will be switched automatically after pressing page change button for a while.
* Revert-back delay: the time to revert back to homepage.
* Self-cycling display time: the interval time setting.

Type: Genset Controller
Speed input: Freq 300Hz～10kHz
Hole size: 67 × 67mm/2.6 × 2.6"
Power consumption: MAX. 2W
Model: DC10K
Power supply input: 8-33VDC
Power generation input: 15-300VAC, 50/60Hz
Dimensions: 78 × 78 × 72mm/3.1 × 3.1 × 2.8"
Oil valve output: MAX. 16A
Motor output: MAX. 10A
Excitation output: MAX. 80mA
Alarm output: MAX. 16A
Working temperature: -30 to 75℃/-86℉ to 167℉
Storage temperature: -40 to 85℃/-104℉ to 185℉
Product weight: 280g/0.6LB
This product offers the best after-sales service.
We are committed to providing you with durable and high quality products.
Thank you for choosing our products!

Includes:

1 × DC10K Genset Controller Generator Controller Engine Item SpecificsCountry of Origin :United StatesBrand :ALL-CARBMPN :MOT4666332Speed input :Freq 300Hz～10kHzType :Genset ControllerWarranty :1YearPower consumption :MAX. 2WModel :DC10KCustom Bundle :NoBundle Description :NoModified Item :NoPower supply input :8-33VDCColor :BlackDimensions :78 × 78 × 72mm/3.1 × 3.1 × 2.8"Hole size :67 × 67mm/2.6 × 2.6"Power generation input :15-300VAC, 50/60HzOil valve output :MAX. 16AMotor output :MAX. 10AExcitation output :MAX. 80mAAlarm output :MAX. 16AWorking temperature :-30 to 75℃/-86℉ to 167℉Storage temperature :-40 to 85℃/-104℉ to 185℉Product weight :280g/0.6LB

PaymentShippingReturnsContact Usresponse We accept Paypal,Google Pay,VISA,Master Card,American Express.Discovere, Mastercard payment. Notice: The Guaranteed Date is automatically generated and displayed by . We can't change it and can't control the speed of delivery, it's depend on the carrier. We will ship your item out asap after the payment is clear.Usually your Items will be shipped within 1-3 business day after your payment is cleared.International orders may take 10 to 30 business days to arrive.We have CA, NJ warehouses and ship items may vary according to the stock. Please contact us first when return, exchange and refund is required.Any direct return of purchased items will not be processed.Change-of-mind return can only be accepted within 7 days after purchase.All other returns can be accepted in 30 days.We will closely examine the condition of the returned items and will not issue any refund/exchange before we make sure the items are in their original neat conditions. And our office is closed on Sunday and we apologize for the late reply during the holidays.Before leaving us neutral or negative response, please contact us first.We will do everything we can to give you a satisfying solution.Please don't open case via or PayPal.We do our best to resolve any issue. Leaving negative response and low ratings doesn't get things solved.So please talk with us and we will not let you down.

We strive for 100% customer satisfaction! response IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative response, so that we can satisfactorily address your concerns.

All rights reserved.

On Sep 4, 2026 at 19:46:49 PDT, seller added the following information: