433MHz Wireless Remote Control Switch Kit – DC 12V, 4 Channels
Add wireless control to compatible lighting and DIY automation projects. This kit includes a 4-channel relay receiver with a protective case and one 4-button remote control with a pre-installed CR2032 battery.
Features
- Four relay channels with passive contacts for switching separate circuits.
- 433MHz RF wireless control.
- Three operating modes: Momentary, Toggle and Latched.
- Stores up to 20 compatible remote controls, according to the supplied manual.
- Manufacturer-stated open-space range exceeds 50 m (approximately 164 ft). Actual range depends on the transmitter, walls, interference and installation.
- Compatible with supported 1527 learning-code and 2262 fixed-code remotes. Not compatible with every 433MHz remote.
Operating Modes
- Momentary: the selected relay stays on while the remote button is held and turns off when released.
- Toggle: press once to turn the selected relay on; press again to turn it off.
- Latched / Interlock: selecting another channel turns the previously selected channel power input: DC 12V
- Frequency: 433MHz
- Number of channels: 4
- Remote buttons: 4 — A, B, C and D
- Receiver type: ASK superheterodyne
- Relay terminals: COM, NO and NC
- Manufacturer-listed maximum switching current: 10A. Allowable load depends on voltage and load type; this is not a universal motor or LED load rating.
- Remote battery: CR2032, pre-installed
Package Includes
- 1 × 4-channel relay receiver
- 1 × receiver case
- 1 × 4-button remote control
- 1 × CR2032 battery, installed in the remote
Power and Installation
The receiver requires a DC 12V power supply. The remote’s battery does not power the receiver.
The manufacturer’s wiring diagram shows switching of separate AC load circuits, including compatible 120V AC loads. 120V AC is the switched load voltage, NOT the receiver’s power input. Never connect AC mains to the DC 12V input.
Check load ratings and wiring requirements before installation. Mains-voltage wiring requires a suitable protective enclosure and installation by a qualified electrician.
For gate or garage-door applications, use only a compatible controller input and retain all existing safety features. This kit is not a universal replacement for every gate or garage-door remote. Pairing and selection of the operating mode may be required before use.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.