10 Inch Rack Mount 4.5U for Ubiquiti UniFi Dream Router 7 UDR7 Homelab PETG

A 4.5U tray that holds the Ubiquiti UniFi Dream Router 7 standing upright, the way Ubiquiti shows it on a desk, in a 10 inch mini rack, printed to order in matte black PETG. The status display looks out through the front window, the LED ring on top stays visible, and the port column faces the back of the rack so every cable exits the rear. The router lifts straight out from the top; no screws, no adhesive.

• Fits: Ubiquiti UniFi Dream Router 7, 110 mm diameter x 184.1 mm tall per Ubiquiti\'s specification.
• Held on every side: open hex side walls rise to 114 mm (62 % of the router\'s height), the window jambs stop it at the front, and two angled rear stops box it in without covering the port column (72 mm open behind it, floor to top).
• Window 84 mm wide, open at the top, over the whole front of the router from 20 mm above the floor.
• Faceplate 254 mm wide, the standard 10 inch width, on EIA-310 10 inch hole spacing; 4.5U (200.0 mm) tall.

• Fits the UniFi Dream Router 7 (UDR7): 110 mm diameter x 184.1 mm, 1.1 kg, per Ubiquiti\'s published specification.
• The router stands upright the way Ubiquiti shows it on a desk; its port column faces the back of the rack, so every cable exits the rear.
• The front status display looks out through the window and the LED ring on top stays in view.
• Open hex side walls and an open honeycomb floor leave the body open for air; the router lifts out without tools.
• Racking a Wi-Fi router can shorten its Wi-Fi range; best for wired setups or with access points elsewhere.

• Single piece.
• The side walls rise into the faceplate to its full height in one continuous curve, and the window jambs run to the top of the faceplate; open honeycomb floor and hex side walls for air.
• Fits any 10 inch / 254 mm mini rack with standard square or round holes. The mounting slots take #10-32, M5 or M4 rack screws.
• Part measures 254 x 120 x 200.0 mm. Matte black PETG.

Each unit is printed fresh in our shop on calibrated printers and inspected before it ships. Lead time is up to 4 business days. Minor layer lines are normal for FDM 3D printing and part of the finish.

Mount only. The router and its power cord and the rack are not included; they appear in the photos for scale and fitment only.

Not an official Ubiquiti product; Ubiquiti is a trademark of its owner.