10 Inch Rack Mount 1U for 2x Raspberry Pi 5 / Pi 4 M.2 HAT+ Active Cooler PETG

A 1U tray that holds 2 Raspberry Pi 5 / Raspberry Pi 4 boards in a 10 inch mini rack, printed to order in matte black PETG. Each board screws down on four printed bosses with its USB and Ethernet edge 1 mm behind the faceplate, so every port is reached through its own window from the front. 35 mm of open floor beside each board\'s USB-C / micro-HDMI edge takes straight plugs.

• Fits: Raspberry Pi 5 and Raspberry Pi 4 Model B: board 85 x 56 mm, 58 x 49 mm mounting-hole pattern, per Raspberry Pi\'s mechanical drawings.
• Stack height: nothing of the tray stands above the boards, so the Raspberry Pi Active Cooler, the M.2 HAT+ on its 16 mm spacers with an SSD, or a PoE+ HAT all fit; the limit is the rack unit above (about 33 mm above the board).
• Windows 58 mm wide per board, from the floor to 20 mm above the board: the USB stacks and the Ethernet jack sit inside.
• Side room 35.7 mm of open floor beside each board\'s USB-C / micro-HDMI edge.
• Faceplate 254 mm wide (the standard 10 inch width) on EIA-310 10 inch hole spacing; 1U (44.5 mm) tall.

• Single piece.
• Open honeycomb floor under every board; vented rhythm-slot face.
• Each board mounts with four M2.5 x 12 mm screws from below (not included): into the M.2 HAT+ or PoE+ HAT spacers, or with an M2.5 nut on a bare board.
• Fits any 10 inch / 254 mm mini rack with standard square or round holes. The mounting slots take #10-32, M5 or M4 rack screws.
• Part measures 254 x 100 x 44.5 mm. Matte black PETG.

Each unit is printed fresh in our shop on calibrated printers and inspected before it ships. Lead time is up to 4 business days. Minor layer lines are normal for FDM 3D printing and part of the finish.

Mount only. Raspberry Pi boards, coolers, HATs, screws and power supplies not included. The rack and the boards shown in the photos are not included; they appear for scale and fitment only.

Not an official Raspberry Pi product; Raspberry Pi is a trademark of its owner.