10 Inch Rack Mount 1.5U for Netgate 2100
A 1.5U tray that seats the Netgate 2100 in a 10 inch mini rack, printed to order in matte black PETG. It slides in from the front, through the window, until it touches the two rear stop posts, and sits about 11 mm proud of the faceplate. No adhesive, no modification to the device.
Designed From The Published Specification
- Fits: Netgate 2100 BASE and 2100 MAX, 6.8 x 4.25 x 1.7 in (172.7 x 108 x 42.2 mm) per Netgate.
- Every connector is on one long face of the 2100: put that face forward to reach the ports through the window, or turn the unit round to show its status LEDs; the rear corner stops clear every connector either way.
- Not for the Netgate 1100, 4200 or 6100 (different sizes).
- Opening 174.7 x 48.5 mm over a flush floor: 1 mm of side clearance and at least 2.5 mm above the 2100 standing on its rubber feet.
- Faceplate 254 mm wide (the standard 10 inch width) on EIA-310 10 inch hole spacing; 1.5U (66.7 mm) tall.
Build
- Single piece.
- Vented rhythm-slot face and an open honeycomb floor.
- Fits any 10 inch / 254 mm mini rack with standard square or round holes. The mounting slots take #10-32, M5 or M4 rack screws.
- Part measures 254 x 105 x 66.7 mm. Matte black PETG.
Printed To Order
Each unit is printed fresh in our shop on calibrated printers and inspected before it ships. Lead time is up to 4 business days. Minor layer lines are normal for FDM 3D printing and part of the finish.
Mount only. Firewall and power adapter not included. The rack and the device shown in the photos are not included; they appear for scale and fitment only.
Not an official Netgate product; Netgate is a trademark of its owner.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.