10 Inch Rack Mount 1.5U for 2x GL.iNet Comet Pro (GL-RM10)
A 1.5U tray that seats two GL.iNet Comet Pro (GL-RM10) units side by side in a 10 inch mini rack, printed to order in matte black PETG. Each KVM slides in through its own bay until it touches the rear stop and sits about 11 mm proud of the faceplate. No adhesive, no modification to the KVM.
Designed From The Published Specification
- Fits: GL.iNet Comet Pro (GL-RM10), 84 x 93 x 47 mm (W x D x H as mounted) per the maker\'s published specification. Two units side by side; the touchscreen faces forward and every cable runs out the back.
- Bays two 86 mm bays split by a 2.6 mm divider, 49.4 mm tall over a flush floor: 1 mm of side clearance and 2.4 mm above the 47 mm body.
- Faceplate 254 mm wide (the standard 10 inch width) on EIA-310 10 inch hole spacing; 1.5U (66.7 mm) tall.
Build
- Single piece.
- Vented rhythm-slot face and an open honeycomb floor.
- Fits any 10 inch / 254 mm mini rack with standard square or round holes. The mounting slots take #10-32, M5 or M4 rack screws.
- Part measures 254 x 90 x 66.7 mm. Matte black PETG.
Printed To Order
Each unit is printed fresh in our shop on calibrated printers and inspected before it ships. Lead time is up to 4 business days. Minor layer lines are normal for FDM 3D printing and part of the finish.
Mount only. Two KVMs and power adapters not included. The rack and the device shown in the photos are not included; they appear for scale and fitment only.
Not an official GL.iNet product; GL.iNet is a trademark of its owner.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.