|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
1/2/5/10PCS Double BTS7960B Stepper Motor Driver DC H-Bridge PWM 43A For Arduino
$8.09

-
-
-
if you have any problem,pls contact with us.
1/2/5/10PCS Double BTS7960B Stepper Motor Driver DC H-Bridge PWM 43A For Arduino This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A
Specification: Double BTS7960 large current (43 A) H bridge driver; 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board; voltage indication of motor driver output end; can solder heat sink; Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V); Size: 4 * 5 * 1.2 cm; Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output; isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V
Package Included:1/2/5/10 x Double BTS7960B DC Stepper Motor Driver H-Bridge PWM 43A Board For Arduino3.Our aim is to provide Top Level Customer Service, normally so we will try our best to solve any problem. 1/2/5/10PCS Double BTS7960B Stepper Motor Driver DC H-Bridge PWM 43A For ArduinoThis driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A
Specification: Double BTS7960 large current (43 A) H bridge driver; 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board; voltage indication of motor driver output end; can solder heat sink; Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V); Size: 4 * 5 * 1.2 cm; Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output; isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V
Package Included:1/2/5/10 x Double BTS7960B DC Stepper Motor Driver H-Bridge PWM 43A Board For Arduino3.Our aim is to provide Top Level Customer Service, normally so we will try our best to solve any problem. Am 03.04.2026 hat der Verkäufer die folgenden Angaben hinzugefügt:

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|