|
>> If you dont know how to design a userbar, then write here a Userbar that you want.
>> If you know how to design them help these people and design what they request.
|
 |
 |
USERBARS.org | Free Forum Userbars
| On eBay now |
1/2/5/10PCS Double BTS7960B 43A Stepper Motor Driver DC H-Bridge PWM For Arduino
$6.79

Keywords you may need:Sensors Tester ESP32 FNIRSI Development Board NodeMCU Multimeter Speed Controller Spot Welder Relay Temperature Controller LCD OLED LED&RGB Adapter Amplifier Power supply Step Up Step down Converter Switch Transmitter Light Singal Generator Dear customer: Thank you for visit our store,we are proffessional "Business & Industrie" seller for 10 years,our main products included:Sensors,modules devolpment board, LED displays, other IC procuts an so on,any question about DIY robot,Arduino,or Raspberry Pi will be welcome to discuss with us,we will try our best to supply the most advanced product and price,(if we sale more,the cost of made one product will be reduce and we will change or price to make you save more. Hope you enjoying yourself here! We appreciate your business! * If a problem occurs, contact us immediately with any email request. * Just contact us using the " Ask the seller a question" link on . 1/2/5/10PCS Double BTS7960B 43A Stepper Motor Driver DC H-Bridge PWM For ArduinoThis driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A
Specification: Double BTS7960 large current (43 A) H bridge driver; 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board; voltage indication of motor driver output end; can solder heat sink; Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V); Size: 4 * 5 * 1.2 cm; Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output; isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V
Package Included:1/2/5/10 x Double BTS7960B 43A Stepper Motor Driver DC H-Bridge PWM For ArduinoAm 13.01.2026 hat der Verkäufer die folgenden Angaben hinzugefügt:

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
|
|
|
 |
 |
|