0.96" SPI 128X64 LED OLED LCD Yellow Blue Color Display Arduino SSD1306 7 pin US

Size: 0.96\"Resolution: 128X64Viewing angle: greater than 160 degreesSupported platforms: for  Arduino, 51 series, MSP430 series, STIM32 / 2, SCR chipsLow power consumption: 0.04W during normal operationSupport wide voltage: 3.3V-5V DCWorking temperature: -30-80 degreesSize: 27MM * 27MM * 4.1MMDriver IC: SSD1306Communication: SPI (7 pin)Backlight: OLED self light, no backlightColor: (Yellow/Blue) Yellow - 16 pixels, Blue - 48 pixels
Interface:GND: GroundVCC: 3.3-5VSCK: Serial ClockSDA: Serial DataRES: Reset (When held to ground momentarily this pin resets the module)DC: Command pin (Can either be used for SPI or for IIC)CS: Chip Select (Normally held low, used only when more than one SPI device is connected to MCU)
What is OLED ?OLED (Organic Light-Emitting Diode) is a self light-emitting technology composed of a thin, multi-layered organic film placed between an anode and cathode. In contrast to LCD technology, OLED does not require a backlight. OLED possesses high application potential for virtually all types of displays and is regarded as the ultimate technology for the next generation of flat-panel displays.
The use of OLED technology offers the following advantages for flat-panel displays ?1. A simplified manufacturing process compared to TFT-LCD (See comparison of Picture 1 and Picture 2 below)2. Self-emitting light, in contrast to the required backlight for TFT-LCD3. High luminosity4. Lightweight and thin (less than 2 mm)5. Low operating voltage and power consumption6. Wide range of operating temperatures (-40℃ to 85℃)
A Comparison of OLED and TFT-LCD Display Technologies
How Does OLED Emit Light ?OLED”s basic structure consists of organic materials positioned between the cathode and the anode, which is composed of electric conductive transparent Indium Tin Oxide (ITO). The organic materials compose a multi-layered thin film, which includes the Hole Transporting Layer (HTL), Emission Layer (EML) and the Electron Transporting Layer (ETL). By applying the appropriate electric voltage, holes and electrons are injected into the EML from the anode and the cathode, respectively. The holes and electrons combine inside the EML to form excitons, after which electroluminescence occurs. The transfer material, emission layer material and choice of electrode are the key factors that determine the quality of OLED components.
Package included:1 x  0.96\" SPI 28X64 LED OLED LCD  Display Module for Arduino Yellow/Blue